Water Pump - Test
Show/hide table
Tools Needed     | ||
Part Number     | Part Name     | Quantity     |
6V-7775     | Air Pressure Gauge     | 1     |
Show/hide table
Illustration 1 | g00750869 |
(1) Port |
Show/hide table
Making contact with a running engine can cause burns from hot parts and can cause injury from rotating parts. When working on an engine that is running, avoid contact with hot parts and rotating parts. |
Perform the following procedure in order to determine if the water pump is operating correctly:
- Remove the plug from port (1).
- Install the 6V-7775 Air Pressure Gauge in port (1) .
- Start the engine. Run the engine until the coolant is at operating temperature.
- Note the water pump pressure. The water pump pressure should be 80 kPa (12 psi) at rated speed and rated load.
Caterpillar Information System:
3126B Marine Engine Air Inlet and Exhaust System - Inspect
3054, 3054B and 3056 Marine Engines Safety Signs and Labels
3126B Marine Engine Turbocharger - Inspect
C-10, C-12, C-15 and C-16 Industrial Engines Engine Temperature Sensor Open or Short Circuit - Test
3054, 3054B and 3056 Marine Engines Overhaul Considerations
3508B Industrial Engine with an ADEM 2 Electronic Control Module Injector Solenoids
3054 and 3056 Industrial and Generator Set Engines Engine Oil Relief Valve
3054, 3054B and 3056 Marine Engines Engine Oil Filter Base
SPP101 Skid Mounted Pumper Diagnostic Flash Code Retrieval
Marine Monitoring System II Resistance Temperature Detector
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Generator Monitoring System Thermocouple Sensor
3054, 3054B and 3056 Marine Engines Engine Rating Definitions
2000/11/01 A New Seal Is Used In The Alternator Mounting Group {1405}
3126B Marine Engine Basic Engine
320C Excavator Plate Locations and Film Locations
3054 and 3056 Marine Generator Set Engines Engine Oil Relief Valve - Remove and Install
C-10, C-12, C-15 and C-16 Industrial Engines Ether Injection System - Test
3054, 3054B and 3056 Marine Engines Air Inlet Heater - Remove and Install
325D and 329D Excavators Work Tool Control (One-Way Flow) - If Equipped
3054, 3054B and 3056 Marine Engines Engine Oil Cooler - Remove and Install - 3056 Engine
3606, 3608, 3612 and 3616 Engines and C280-12, C280-16, C280-6 and C280-8 Marine Engines Generator Monitoring System Configuration Record
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Cylinder Head
3406E and 3456 Engines for Caterpillar Built Machines Cylinder Head Valves
Marine Monitoring System II RSView Software for Optional Computer