Fuel Shutoff Solenoid - Test
Show/hide table
Illustration 1 | g00860355 |
(1) Fuel shutoff solenoid (2) Plunger |
This procedure tests the fuel shutoff solenoid for correct operation.
- Remove the fuel shutoff solenoid from the engine. Refer to Disassembly and Assembly, "Fuel Shutoff Solenoid - Remove and Install".
- Connect the fuel shutoff solenoid to the test circuit that is shown in Illustration 2.
- When the start button is pushed, plunger (2) should retract. The plunger should remain retracted until the circuit is de-energized by the stop switch. If the fuel shutoff solenoid fails this test, replace the fuel shutoff solenoid.
Show/hide table
Illustration 2 | g00713506 |
- Install the fuel shutoff solenoid on the engine. Refer to Disassembly and Assembly, "Fuel Shutoff Solenoid - Remove and Install".
Caterpillar Information System:
3126B and 3126E On-highway Engines Intermittent Low Power or Power Cutout
2002/05/20 Improved Electric Fuel Shutoff Solenoid {1259}
G3516B Engines Engine Speed/Timing Sensor - Calibrate
Programmable Relay Control Module (PRCM) Fault Identification
Programmable Relay Control Module (PRCM) General Information
Programmable Relay Control Module (PRCM) Service Tools
Installation Instructions for 192-1511 Air Conditioner Gp and for 192-5372 Air Conditioner Gp {7320} Installation Instructions for 192-1511 Air Conditioner Gp and for 192-5372 Air Conditioner Gp {7320}
3126B and 3126E On-highway Engines Intermittent Engine Shutdown
2000/06/01 New Hydraulic Wrenches and Pumps {0602, 0615}
G3516B Engines E866 Low Gas Fuel Flow Rate
Programmable Relay Control Module (PRCM) Setpoint Viewing and Programming
G3516B Engines E865 High Gas Fuel Differential Pressure
G3516B Engines E867 Improper Gas Flow Control Valve Response
G3516B Engines E868 Gas Flow Control Valve Malfunction
Programmable Relay Control Module (PRCM) Troubleshooting Diagnostic Codes
3126B and 3126E On-highway Engines Excessive Black Smoke
3126B and 3126E On-highway Engines Excessive White Smoke
3126B Engines for Caterpillar Built Machines Flywheel Housing - Remove and Install
SR4 and SR4B Electric Power Generation Rewind Data Winding Data for <B>4W-0183</B> Generator through <B>4W-9669</B> Generator
Programmable Relay Control Module (PRCM) PRCM CID 0248 - FMI 11
C-10, C-12, 3406E, C-15, C-16 and C-18 Engines - Electronic PTO Installation and Application PTO Switch Circuit - Test
2000/10/01 Use159-9404 Counterbore Tool Group to Bore Cylinder Block {1201, 1217}
Electronic Modular Control Panel II (EMCP II) for EUI Engines Data Link
3126B and 3126E On-highway Engines Poor Acceleration or Response