G3516B Engines Caterpillar


E868 Gas Flow Control Valve Malfunction

Usage:

G3516B 7EZ
Conditions Which Generate This Code:

The Electronic Control Module (ECM) has detected a malfunction for the fuel metering valve and the delay time has expired.

System Response:

The alarm output is activated. The code is logged.

Possible Performance Effect:

The engine performance is not immediately affected.

Troubleshooting:

Test Step 1.

Refer to Troubleshooting, "Fuel Metering Valve".

Results:

  • OK - STOP

Caterpillar Information System:

G3516B Engines E867 Improper Gas Flow Control Valve Response
3034 Engine for Caterpillar Built Machines Fuel Shutoff Solenoid - Test
3126B and 3126E On-highway Engines Intermittent Low Power or Power Cutout
2002/05/20 Improved Electric Fuel Shutoff Solenoid {1259}
G3516B Engines Engine Speed/Timing Sensor - Calibrate
Programmable Relay Control Module (PRCM) Fault Identification
Programmable Relay Control Module (PRCM) General Information
Programmable Relay Control Module (PRCM) Service Tools
Installation Instructions for 192-1511 Air Conditioner Gp and for 192-5372 Air Conditioner Gp {7320} Installation Instructions for 192-1511 Air Conditioner Gp and for 192-5372 Air Conditioner Gp {7320}
3126B and 3126E On-highway Engines Intermittent Engine Shutdown
2000/06/01 New Hydraulic Wrenches and Pumps {0602, 0615}
G3516B Engines E866 Low Gas Fuel Flow Rate
Programmable Relay Control Module (PRCM) Troubleshooting Diagnostic Codes
3126B and 3126E On-highway Engines Excessive Black Smoke
3126B and 3126E On-highway Engines Excessive White Smoke
3126B Engines for Caterpillar Built Machines Flywheel Housing - Remove and Install
SR4 and SR4B Electric Power Generation Rewind Data Winding Data for <B>4W-0183</B> Generator through <B>4W-9669</B> Generator
Programmable Relay Control Module (PRCM) PRCM CID 0248 - FMI 11
C-10, C-12, 3406E, C-15, C-16 and C-18 Engines - Electronic PTO Installation and Application PTO Switch Circuit - Test
2000/10/01 Use159-9404 Counterbore Tool Group to Bore Cylinder Block {1201, 1217}
Electronic Modular Control Panel II (EMCP II) for EUI Engines Data Link
3126B and 3126E On-highway Engines Poor Acceleration or Response
120H and 135H Motor Graders Engine Stopping
3406E, C-10 and C-12 On-highway Engines Excessive Fuel Consumption
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.