Piston Cooling Jet
Note: Piston cooling jets are installed on turbocharged engines only.
Show/hide table
Illustration 1 | g00721168 |
(1) Banjo bolt
- Tighten the banjo bolt for the piston cooling jet to the following torque. ... 27 N·m (20 lb ft)
(2) Piston cooling jet
Alignment
Show/hide table
Required Tools     | ||
Part Number     | Part Name     | Qty     |
FT-2736     | Alignment Gauge     | 1     |
Show/hide table
Illustration 2 | g00712686 |
To align the piston cooling jet, use the following procedure:
- Build an alignment gauge (4) out of 3 mm (0.12 inch) plexiglass. For the correct dimensions, see the print for FT-2736 Alignment Gauge .
- Install the alignment gauge on pins (1) of the cylinder head.
- Insert a rod (2) that is 1.2 mm (0.05 inch) in diameter into each piston cooling jet. The rods must protrude through holes (3) in order for the piston cooling jet to be aligned properly. If the rods do not protrude through the holes in the alignment tool, bend the piston cooling jet. Check the rods again for correct alignment.
- Remove the alignment gauge and the rods.
Caterpillar Information System:
3034 Engine for Caterpillar Built Machines Flywheel Housing
2000/03/01 190-02 "Loss of Engine RPM Signal" with an ADEM II ECM {1901, 1912}
G3516B Engines Engine Misfires, Runs Rough or Is Unstable
G3516B Engines Engine Cranks but Will Not Start
3034 Engine for Caterpillar Built Machines Fuel Filter Base
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Flywheel Housing
3126 Truck Engine Military Housing (Front) - Remove
G3516B Engines Engine Will Not Crank
G3304 and G3306 Engines Battery
3612 and 3616 Engines Test Tools for the Electrical System
3612 and 3616 Engines Lubricator and Strainer
3612 and 3616 Engines Pressure Regulating Valve
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Fuel Injection Nozzle - Test
SR4 and SR4B Electric Power Generation Rewind Data Winding Data for <B>5N-0051</B> Generator through <B>5N-0075</B> Generator
2000/04/17 A New 169-4309 Mounting Bar Provides Easier Alignment of Heat Exchanger Plates {0708, 1379}
2000/04/01 Improved Water Connection Group {1393}
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Glow Plugs - Test
2000/04/01 Oil Mister Pump And Lines Groups No Longer Used {1105, 1319}
3114, 3116, and 3126 Engines Air Inlet and Exhaust System
3046 Engine for Caterpillar Built Machines Engine Oil Pressure Switch - Test
3046 Engine for Caterpillar Built Machines Coolant Temperature Switch - Test
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Fuel Shutoff Solenoid - Test
3064 and 3066 Engines for Caterpillar Built Machines Alternator - Test
2000/04/17 New 171-4660 Engine Stand Adapter Assembly Is Now Available {0701, 1000}