Separation Procedure
Start By:
- Remove the mounting bracket. Refer to Disassembly and Assembly, "Mounting Bracket - Remove and Install".
- Remove the gerotor motor. Refer to Disassembly and Assembly, "Gerotor Motor - Remove".
| NOTICE |
|---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat products. Dispose of all fluids according to local regulations and mandates. |
When possible, position the work tool upright. The work tool should only be positioned in an upright position on a solid, level surface. If a solid level surface is not available, lay the work tool on a side.
 |
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
 |
|
Disconnect the hydraulic hoses before uncoupling the work tool from the machine in order to prevent the work tool from moving, and the possibility of injury or death. |
|
- Remove plate (1). Repeat for the other side.
 | |
| Illustration 1 | g01195000 |
- Disconnect hose assemblies (2). Remove bolts (3) and remove plate (4) .
 | |
| Illustration 2 | g01195001 |
- Remove bolts (5), but leave two bolts (5) at 180 degrees of each other. Attach a suitable lifting device to hydraulic rotator (6). The weight of hydraulic rotator (6) is between 499 kg (1100 lb) and 680 kg (1500 lb). Remove the remaining bolts (5) and remove hydraulic rotator (6) .
 | |
| Illustration 3 | g01195004 |
 | |
| Illustration 4 | g01195005 |
- Remove V ring seal (7) .
 | |
| Illustration 5 | g01195017 |