Fan - Remove and Install
Removal Procedure
Show/hide table
 |
At operating temperature, the engine coolant is hot and under pressure. Steam can cause personal injury. Check the coolant level only after the engine has been stopped and the fill cap is cool enough to touch with your bare hand. Remove the fill cap slowly to relieve pressure. Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury. |
 |
Show/hide table
| NOTICE |
|---|
Do not allow the fan assembly to strike the radiator core during removal. Damage to the radiator core can result. |
- Drain the coolant below the level of hose (1) into a suitable container for storage or disposal. Disconnect hose (1). Remove top fan guard (2) only.
Show/hide table
 | |
| Illustration 1 | g01182480 |
- Remove bolts (3) and fan (4) .
Show/hide table
 | |
| Illustration 2 | g01182483 |
Installation Procedure
- Position fan (4) and install bolts (3) .
Show/hide table
| | |
| Illustration 3 | g01182483 |
- Install top fan guard (2). Connect hose (1) .
Show/hide table
| | |
| Illustration 4 | g01182480 |
- Fill the cooling system. Refer to Operation and Maintenance Manual, "Cooling System Level - Check".
Caterpillar Information System:
365C Excavator Engine Supplement Water Temperature Regulator - Remove and Install
301.6C and 301.8C Mini Hydraulic Excavators Machine Systems Swing Drive - Install
301.6C and 301.8C Mini Hydraulic Excavators Machine Systems Swing Drive - Remove
301.6C and 301.8C Mini Hydraulic Excavators Machine Systems Bucket Cylinder - Remove and Install
Installation of Replacement Switches for the Travel Alarm on Mini Hydraulic Excavators{7429} Installation of Replacement Switches for the Travel Alarm on Mini Hydraulic Excavators{7429}
303.5C CR and 303C CR Mini Hydraulic Excavators Hydraulic System Travel Counterbalance Valve
365C Excavator Engine Supplement Engine Oil Filter Base - Install
365C Excavator Engine Supplement Engine Oil Filter Base - Remove
C7.1 (Mech) Industrial Engine Gear Group (Front)
C7.1 (Mech) Industrial Engine Oil Pump
C9 Generator Set Engine Crankcase Breather - Clean
C7.1 Engines for Caterpillar Built Machines Front Housing and Covers
365C Excavator Engine Supplement Ether Start Valve - Remove and Install
302.5C Mini Hydraulic Excavator Machine Systems Swing Boom Cylinder - Remove and Install
301.6C and 301.8C Mini Hydraulic Excavators Hydraulic System Travel Counterbalance Valve
301.6C and 301.8C Mini Hydraulic Excavators Machine Systems Bucket Linkage - Remove and Install
365C Excavator Engine Supplement Engine Electronic Control - Remove and Install
365C Excavator Engine Supplement Fuel Cooler - Remove and Install
365C Excavator Engine Supplement Fuel Filter (Secondary) and Fuel Filter Base - Remove and Install
365C Excavator Engine Supplement Fuel Priming Pump - Remove and Install
365C Excavator Engine Supplement Fuel Transfer Pump - Remove and Install
C6.6 Engines for Caterpillar Built Machines Crankshaft
314E Excavator Machine System Specifications Check Valve (Return Lines)
2005/07/04 New Software Reduces the Trip Points on the Fuel Pressure Sensor {1718, 7620}