Installation Procedure
Required Tools     | |||
Tool     | Part Number     | Part Description     | Qty     |
A     | 5P-0306     | Vacuum Transducer     | 1     |
FT-1115 | Vacuum Cap     | 1     | |
6V-4142 | Fitting     | 1     | |
5K-5068 | Fitting     | 1     |
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install support (6) and accumulator (5) onto control manifold (1) .
Illustration 1 | g01180927 |
- Position control manifold (1) and install bolts (3). Connect harness assemblies (4) and hose assemblies (2) .
Illustration 2 | g01180925 |
- Close the rear, right hand access door.
- Remove Tooling (A). Install the cap onto the hydraulic tank.
Illustration 3 | g00944947 |
- Fill the hydraulic system. Refer to Operation and Maintenance Manual, "Hydraulic System Oil Level - Check". Refer to Operation and Maintenance Manual, "Lubricant Viscosities and Refill Capacities".