Check Valve (Cooler Bypass) - Assemble
Assembly Procedure
Note: Cleanliness is an important factor. Before assembly, all parts should be thoroughly cleaned in cleaning fluid. Allow the parts to air dry. Wiping cloths or rags should not be used to dry parts. Lint may be deposited on the parts which may cause later trouble. Inspect all parts. If any parts are worn or damaged, use new parts for replacement.
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install adapter (5), poppet (6), spring (7), sleeve assembly (8), and nut (9) on bolt assembly (4). Tighten nut (9) to a torque of 9 ± 1 N·m (80 ± 9 lb in).
Show/hide table
Illustration 1 | g01177068 |
Show/hide table
Improper assembly of parts that are spring loaded can cause bodily injury. To prevent possible injury, follow the established assembly procedure and wear protective equipment. |
- Install bolt assembly (4). Install check valve assembly (2) and retaining ring (1) into block (3) .
Show/hide table
Illustration 2 | g01177065 |
Caterpillar Information System:
325C LCR Excavator Machine Systems Check Valve (Cooler Bypass) - Disassemble
325C LCR Excavator Machine Systems Check Valve (Cooler Bypass) - Remove
2005/06/13 Addition to Troubleshooting , "Injection Actuation Pressure - Test" {1714}
322C Excavator Specifications
325D Forest Machine Hydraulic System Main Hydraulic Pump
325C LCR Excavator Machine Systems Solenoid Valve (Auxiliary Circuit) - Install - 1-Way, Check
325C LCR Excavator Machine Systems Solenoid Valve (Auxiliary Circuit) - Remove - 1-Way, Check
325C LCR Excavator Machine Systems Solenoid Valve (Auxiliary Circuit) - Install - 1-Way/2-Way, Check
325C LCR Excavator Machine Systems Solenoid Valve (Auxiliary Circuit) - Remove - 1-Way/2-Way, Check
C13, C15, and C18 Tier 4 Final Engines Fuel Transfer Pump
301.6C and 301.8C Mini Hydraulic Excavators Machine Systems Swivel - Install
330D and 336D Excavators and 336D MHPU Mobile Hydraulic Power Unit Boom/Stick/Bucket Combinations
325C LCR Excavator Machine Systems Check Valve (Cooler Bypass) - Install
C13, C15, and C18 Tier 4 Final Engines Crankshaft Seals
301.6C and 301.8C Mini Hydraulic Excavators Machine Systems Main Hydraulic Pump and Gear Pump (Pilot) - Remove
C13, C15, and C18 Tier 4 Final Engines Valve Mechanism
302.5C Mini Hydraulic Excavator Machine Systems Main Control Valve - Install
324D and 326D Excavators Boom/Stick/Bucket Combinations
345C Excavator Automatic Lubrication System General Information
345C Excavator Automatic Lubrication System Lubrication Pump
Hydraulic Cylinder Honing {7562} Hydraulic Cylinder Honing {7562}
345C Excavator Automatic Lubrication System Lubrication Distribution Valve
C175 Generator Sets High Pressure Fuel Lines
C9 Engines for Caterpillar Built Machines Coolant Temperature Sensor