Check Valve (Cooler Bypass) - Disassemble
Disassembly Procedure
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.
Show/hide table
| NOTICE |
|---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove retaining ring (1) and check valve assembly (2) from block (3) .
Show/hide table
 | |
| Illustration 1 | g01177065 |
Show/hide table
 |
Personal injury can result from being struck by parts propelled by a released spring force. Make sure to wear all necessary protective equipment. Follow the recommended procedure and use all recommended tooling to release the spring force. |
 |
- Remove bolt assembly (4) .
- Remove nut (9), sleeve assembly (8), spring (7), poppet (6), and adapter (5), from bolt assembly (4) .
Show/hide table
 | |
| Illustration 2 | g01177068 |
Caterpillar Information System:
325C LCR Excavator Machine Systems Check Valve (Cooler Bypass) - Remove
2005/06/13 Addition to Troubleshooting , "Injection Actuation Pressure - Test" {1714}
322C Excavator Specifications
325D Forest Machine Hydraulic System Main Hydraulic Pump
325C LCR Excavator Machine Systems Solenoid Valve (Auxiliary Circuit) - Install - 1-Way, Check
325C LCR Excavator Machine Systems Solenoid Valve (Auxiliary Circuit) - Remove - 1-Way, Check
325C LCR Excavator Machine Systems Solenoid Valve (Auxiliary Circuit) - Install - 1-Way/2-Way, Check
325C LCR Excavator Machine Systems Solenoid Valve (Auxiliary Circuit) - Remove - 1-Way/2-Way, Check
C13, C15, and C18 Tier 4 Final Engines Fuel Transfer Pump
301.6C and 301.8C Mini Hydraulic Excavators Machine Systems Swivel - Install
330D and 336D Excavators and 336D MHPU Mobile Hydraulic Power Unit Boom/Stick/Bucket Combinations
2005/06/13 An Improved Butt Weld Reduces Internal Stress on the Boom {6501}
325C LCR Excavator Machine Systems Check Valve (Cooler Bypass) - Assemble
325C LCR Excavator Machine Systems Check Valve (Cooler Bypass) - Install
C13, C15, and C18 Tier 4 Final Engines Crankshaft Seals
301.6C and 301.8C Mini Hydraulic Excavators Machine Systems Main Hydraulic Pump and Gear Pump (Pilot) - Remove
C13, C15, and C18 Tier 4 Final Engines Valve Mechanism
302.5C Mini Hydraulic Excavator Machine Systems Main Control Valve - Install
324D and 326D Excavators Boom/Stick/Bucket Combinations
345C Excavator Automatic Lubrication System General Information
345C Excavator Automatic Lubrication System Lubrication Pump
Hydraulic Cylinder Honing {7562} Hydraulic Cylinder Honing {7562}
345C Excavator Automatic Lubrication System Lubrication Distribution Valve
C175 Generator Sets High Pressure Fuel Lines