3524B Engines for 797 and 797B Off-Highway Trucks Caterpillar


Cold Mode Operation

Usage:

3524B 1AW
在冷起动模式期间,燃油喷射会受限制,并通过电子控制模块(ECM)进行燃油喷射正时调节。 冷起动模式可降低发动机损坏的可能性,并有助于最大程度地减少白烟。

在低温模式期间,将根据发动机冷却液温度进行正时。

当发动机冷却液温度低于 70 °C (158 °F) 时,冷起动模式启动。 冷起动模式保持启用状态,直到发动机冷却液温度超过 72 °C (162 °F)

Caterpillar Information System:

A19B and A26B Augers Gerotor Motor - Install
A19B and A26B Augers Gerotor Motor - Remove
A19B and A26B Augers Auger Planetary and Gerotor Motor - Install
A19B and A26B Augers Auger Planetary and Gerotor Motor - Remove
C15 and C18 Engines for Caterpillar Built Machines Engine Oil Pump - Remove
301.5, 301.6 and 301.8 Mini Hydraulic Excavators Window (Front) - Later Type (If Equipped)
302.5 Mini Hydraulic Excavator Engine Starting
C15 and C18 Engines for Caterpillar Built Machines Turbocharger - Assemble
C15 and C18 Engines for Caterpillar Built Machines Turbocharger - Disassemble
5110B Excavator Maintenance Interval Schedule
Bench Test Procedure for Hydraulic Piston Pumps {5070} Bench Test Procedure for Hydraulic Piston Pumps {5070}
345B Excavator Hydraulic System Relief Valve (Line) - Test and Adjust - Equipped with Boom and Stick Lowering Control Valves
A19B and A26B Augers Auger Planetary - Disassemble
C15 and C18 Engines for Caterpillar Built Machines Engine Oil Pump - Install
A19B and A26B Augers Auger Planetary - Assemble
307C Excavator Lifting Capacities
2004/03/29 Special Instruction, REHS1037 , "Installation Instructions for the Electric Fuel Priming Pump on Caterpillar Equipment With the 24 Volt System" has been Revised {1258}
C15 and C18 Generator Set Engines Inlet and Exhaust Valve Springs - Remove and Install
311C-330C, 345B Series II, 365B and 385B Excavators Fuel Tank Shutoff and Drain Control
Conversion of High Flow Work Tools For Operation on High Flow Skid Steer Loaders and Multi Terrain Loaders{1408, 5057, 7553} Conversion of High Flow Work Tools For Operation on High Flow Skid Steer Loaders and Multi Terrain Loaders{1408, 5057, 7553}
325C Forest Machines Machine Systems Swing Drive - Remove
A19B and A26B Augers Mounting Bracket - Remove and Install
C15 and C18 Generator Set Engines Inlet and Exhaust Valves - Remove and Install
311C-330C, 345B Series II, 365B and 385B Excavators Fuel Tank Water and Sediment - Drain
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.