Pinion Clearance Adjustment
安装电磁阀时,应对小齿轮间隙进行调整。 该调整可在拆下起动马达的情况下进行。
Show/hide table
图 1 | g01192756 |
用以检查小齿轮间隙的电气连接 (1) 接地端子 (2) SW 接线端子 (3) 连接片 |
- 安装电磁阀,并不与马达电磁阀上 MOTOR 连接(端子)的连接片 (3) 相连。
- 将与电磁阀具有相同电压的蓄电池连接到 "SW"接线端子 (2) 上。
- 将蓄电池的另一端连接到连接片 (3)上。
- 用导线将标有 "MOTOR"字样的电磁阀连接(端子)与接地连接(端子)短暂相连。 小齿轮会切换到盘车位置,直到断开蓄电池为止。
Show/hide table
图 2 g01192757 小齿轮间隙调整
(4) 轴螺母
(5) 小齿轮
(6) 小齿轮间隙 - 将小齿轮推向整流子一侧,使其无法自由移动。
- 小齿轮间隙 (6)应为
9.1 毫米 (0.36 英寸) 。 - 调整小齿轮间隙时,应拆下螺塞并转动轴螺母 (4)。
Caterpillar Information System:
3500B and 3500B High Displacement Generator Set Engines Electric Starting System
3524B Engines for 797 and 797B Off-Highway Trucks Alternator Regulator
3114, 3116 and 3126 MUI Engine Governors Governor (Type II) - Assemble
G3500B Engines Inlet Air System - Inspect
3500 Engines For Caterpillar Built Power Modules Test Tools for the Electrical System
G3304 and G3306 Engines Magneto
G3304 and G3306 Engines Magneto
3524B Engines for 797 and 797B Off-Highway Trucks Vibration Damper
G3304 and G3306 Engines Magneto
G3304 and G3306 Engines Magneto
G3304 and G3306 Engines Magneto
3508B Engine for Caterpillar Built Machines Flywheel and Flywheel Housing
C-12, C-15 and C-16 Engines for Caterpillar Built Machines ECM Will Not Accept Factory Passwords
3608 Engine Engine Speed Governing
G3304 and G3306 Engines Coolant Temperature Contactor
3126 Truck Engine Military Inlet and Exhaust Valves - Remove and Install
3608 Engine Aftercooler Condensation - Drain
3608 Engine Control Panel
3608 Engine Air Shutoff - Test
3608 Engine Barring Device - Lubricate
G3304 and G3306 Engines Pressure Switch
3608 Engine Inlet Valve Lubrication Metering Pump
3608 Engine Cooling System Coolant Level - Check
3608 Engine Before Starting Engine