Air Inlet Choke - Disassemble
开始:
- 卸下阻风门。
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损並縮短部件使用寿命。 |
Show/hide table
图 1 | g00590713 |
- 卸下螺栓 (1)。 卸下阻风门板 (4)。
- 卸下两个螺栓。 卸下垫圈 (3)。
- 卸下固定螺钉。
- 从壳体 (5) 上卸下调整螺母和螺栓。
- 卸下两个螺栓和板。
- 从阻风门壳体上卸下轴 (2)。
Caterpillar Information System:
G3612 and G3616 Engines Air Inlet Choke - Remove
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 445 FMI 12 Run Relay Failed - Test
G3612 and G3616 Engines Junction Box (Hydrax) - Remove and Install
C9 On-Highway Truck Engines Unit Injector Hydraulic Pump - Remove
Generator Set Load Sensor Phasing - Adjust
3114, 3116 and 3126 Engines Alternator Noise
G3612 and G3616 Engines Hydraulic Tank (Hydrax) - Remove and Install
G3612 and G3616 Engines Hydraulic Oil Pump (Hydrax) - Remove and Install
3500B Engines Air Inlet Manifold - Remove and Install
G3612 and G3616 Engines Caterpillar Ignition System (CIS) Module - Remove and Install
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 444 FMI 12 Starting Motor Relay Failed - Test
G3612 and G3616 Engines Actuator (Hydrax) - Assemble
3114, 3116 and 3126 Engines Engine Misfires, Knocks, or Is Unstable (at Idle Only)
G3612 and G3616 Engines Air Inlet Choke - Assemble
G3612 and G3616 Engines Air Inlet Elbow - Remove and Install
3034 Industrial Engine Cold Weather Starting
3114, 3116 and 3126 Engines Engine Overspeeds on Start
G3612 and G3616 Engines Air Starting Motor - Disassemble
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 446 FMI 12 Air Shutoff Relay Failed - Test
SR4B Generators Generator - Install
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 447 FMI 12 Fuel Control Relay Failed - Test
3044C Industrial Engine Fuel Conservation Practices
G3612 and G3616 Engines Generator - Remove and Install
3500B Engines Water Pump - Install