Engine Oil Pressure Sensor - Remove and Install
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Disconnect harness assembly (1).
- Remove engine oil pressure sensor (2) from the adapter on the cylinder block .
- Remove the O-ring seal from the engine oil pressure sensor.
Show/hide table
| |
| Illustration 1 | g01004482 |
Show/hide table
| NOTICE |
|---|
|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install a new O-ring seal on the engine oil pressure sensor.
- Install engine oil pressure sensor (2). Tighten the engine oil pressure sensor to a torque of
10 ± 2 N·m (89 ± 18 lb in) . - Connect harness assembly (1).
Show/hide table
|
| |
| Illustration 2 | g01004482 |
Caterpillar Information System:
3512B Marine Auxiliary Engine Electrical Power Supply
3512B Marine Auxiliary Engine Digital Sensor Supply
3512B Marine Auxiliary Engine CAT Data Link
3512B Marine Auxiliary Engine Analog Sensor Supply
3054 and 3056 Industrial and Generator Set Engines Engine Storage
G3612 and G3616 Engines Gas Pressure Regulator - Assemble
G3612 and G3616 Engines Gas Pressure Regulator - Disassemble
SR4B Generators Generator - Align
G3612 and G3616 Engines Gas Pressure Regulator - Install
G3612 and G3616 Engines Gas Pressure Regulator - Remove
C9 Engine For Caterpillar Built Machines Engine Oil Pump - Assemble
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 334 FMI 4 Spare Output Voltage Below Normal - Test
3114, 3116 and 3126 Engines Excessive Blue Smoke
G3612 and G3616 Engines Actuator (Hydrax) - Remove
G3612 and G3616 Engines Actuator (Hydrax) - Install
G3612 and G3616 Engines Actuator (Hydrax) - Disassemble
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 443 FMI 12 Crank Termination Relay Failed - Test
G3612 and G3616 Engines Actuator (Hydrax) - Assemble
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 444 FMI 12 Starting Motor Relay Failed - Test
G3612 and G3616 Engines Caterpillar Ignition System (CIS) Module - Remove and Install
3500B Engines Air Inlet Manifold - Remove and Install
G3612 and G3616 Engines Hydraulic Oil Pump (Hydrax) - Remove and Install
G3612 and G3616 Engines Hydraulic Tank (Hydrax) - Remove and Install
3114, 3116 and 3126 Engines Alternator Noise