Engine Oil Pump - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Inspect the condition of the O-ring seal. Replace the seal, if necessary.
Note: Ensure that the mounting surfaces for the engine oil pump are thoroughly clean.
- Install the O-ring seal. Position engine oil pump (3) on the cylinder block.
Show/hide table
Illustration 1 | g00894501 |
- Install two bolts (1) and bolt (2) .
End By: Install the engine oil pan. Refer to Disassembly and Assembly, "Engine Oil Pan - Remove and Install".
Caterpillar Information System:
3126 Truck Engine Military Engine Oil Pump - Remove
3406E Generator Set Engines Customer Specified Parameters
SR4B Generators Leads - Connect
3114, 3116 and 3126 Engines Loss of Coolant
3114, 3116 and 3126 Engines Little or No Valve Lash
3114, 3116 and 3126 Engines Air Inlet Heater - If Equipped
3054B Industrial Engine Reference Material
3126B Engines for Caterpillar Built Machines Water Pump - Assemble
C-15, C-16 and C-18 Truck Engines Water Temperature Regulator - Remove and Install
SR4B Generators Resistor - Test
SR4B Generators Winding - Test
3126B Engines for Caterpillar Built Machines Water Pump - Disassemble
3126 Truck Engine Military Engine Oil Pump - Disassemble
SR4B Generators Exciter Field - Flash
C-9 Engines for Caterpillar Built Machines Lifter Group
SR4B Generators Generator - Dry
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 190 FMI 2 Speed Sensor (Engine) Incorrect Signal - Test
G3304 and G3306 Engines Valve Mechanism
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 190 FMI 3 Speed Sensor (Engine) Voltage Above Normal - Test
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 248 FMI 9 CAT Data Link Abnormal Update - Test
G3612 and G3616 Engines Cylinder Head - Assemble
3126B Engines for Caterpillar Built Machines Unit Injector Sleeve - Install
Electronic Modular Control Panel II (EMCP II) For MUI Engines CID 330 FMI 7 Unexpected Shutdown Improper Mechanical Response - Test
3114, 3116 and 3126 MUI Engine Governors Governor (Type VI) - Disassemble