Accessory Drive (Front) - Install
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Place clean engine oil on the O-ring seals for front adapter assembly (3).
Note: Ensure that the teeth of the accessory gear are correctly engaged with the teeth of the lower accessory drive gear.
- Install the shaft, the drive gear, and front adapter assembly (3) in the front housing. Install the bolts.
- Install the front cover.
Show/hide table
Illustration 2 g00587600 Typical example - Place clean engine oil on the O-ring seals on rear adapter assembly (1) and on the bearing in rear adapter assembly (1).
- Ensure that the O-ring seal is installed in rear cover (2).
- Place clean engine oil on the O-ring seal. Install rear cover (2) and install the bolts.
Show/hide table
Illustration 1 | g00587657 |
Typical example |
Caterpillar Information System:
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Engine Oil Filter Base
3116 Truck Engine Auxiliary Engine Brakes
G3500 Engines Accessory Drive (Front) - Remove
3304B and 3306B Engines for Caterpillar Built Machines Camshaft Bearings - Remove and Install
3524B Engine for Caterpillar Built Machines Gear Group (Rear) - Install
365B Excavator Cab Air Filter (Fresh Air) - Clean/Replace
3524B Engine for Caterpillar Built Machines Gear Group (Rear) - Remove
345B Excavator Bucket Tips - Inspect/Replace
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Fuel Injection Lines - Remove and Install
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Exhaust Elbow
G3500 Engines Crankcase Breather - Remove and Install
3054 and 3056 Industrial and Generator Set Engines Alternator and Regulator
3408E and 3412E Engines for Caterpillar Built Machines Gear Group (Rear) - Install
3524B Engine for Caterpillar Built Machines Accessory Drive (Front) - Disassemble
3512B and 3516B Engines Engine Design
3512B and 3516B Engines Engine Design
3304B and 3306B Engines for Caterpillar Built Machines Crankshaft - Remove
3176C and 3196 Industrial Engines Maintenance Interval Schedule
CIPI UNDERCARRIAGE Arrangements: 1667049, 2372904, 3Q6481, 6Z7988, 6Z7989, 9Q5032, 9Q5040, 9Q5043, 9Q5046, 9Q5047, 9Q5066, 9Q5074, 9Q5097, 9Q5098, 9Q5116, 9Q5134, 9Q5136, 9Q5142, 9Q5147, 9Q5148, 9Q5149, 9Q5172 and 9Q5204 General Testing and Adjusting Information
3524B Engine for Caterpillar Built Machines Accessory Drive (Front) - Assemble
3304B and 3306B Engines for Caterpillar Built Machines Piston Cooling Jets - Remove and Install
CIPI UNDERCARRIAGE Arrangements: 9Q-5262, 191-4041, and 204-9207 Visual Inspection
3114, 3116 and 3126 Industrial, Marine and Generator Set Engines Water Pump
3508, 3512 and 3516 Generator Set Engines Crankshaft Rear Seal and Wear Sleeve - Remove