Use 149-2872 Tooth Pin Remover Group For Removing Pins From Small Bucket Teeth {6822}
Usage:
J200 through J450 Buckets
Warranty Category: M
Features/Benefits
-
- * Used to remove pins as small as 15.5 mm (.61 in) from bucket teeth
- * Used with 8T-3130 Wrench (7/8) - allows removal of teeth as close as 132 mm (5.2 in) apart
- * Tool loosens pins so they can be removed with pliers
- * Two adapters available for correct alignment; one for J200-J400 Series, another for J450 Series teeth
- * Used to remove pins as small as 15.5 mm (.61 in) from bucket teeth
149-2872 Tooth Pin (Small Bucket) Remover Group
Caterpillar Information System:
1998/11/23 Use 154-9740 Wire Connector Rework Kit For Solid Cable To Component Connections {1408}
1998/11/23 Use 153-8538 Refrigerant Solvent For Air Conditioner Refrigerant Flushing Units {0708}
1998/11/23 Use 155-8795 Crankshaft Gauge To Determine Distortion {1202}
1998/11/23 Use 155-1536 Valve Recession Tool Kit To Determine Valve Wear {1103}
1998/11/23 Change In Location And Size Of Crankshaft Counterweight Sequence Number {1231,1202}
1998/11/23 Use FT2617 Bracket Assembly To Support Pumps When Removing Engine {1003}
1998/11/23 Larger Value Backup Resistors Are Used In Electronic Wiring Group To Limit PRV Solenoids For Main Pump And Swing Pump {1437}
1998/11/23 New Radio Requires Preventive Maintenance To Eliminate Battery Drain {7338}
1998/11/23 The Solenoid Valve Group Used For Low Flow Attachment Has Improved Performance {5051,5479}
1998/11/23 Be Sure Electronic Controllers Are Grounded At Machine Service Inspections {1408,1901,5702}
1998/11/23 New Check Valve Used For Refueling Pump {1295}
1998/11/23 New Seal Kits Prevent Hydraulic Cylinder Oil Leaks {5456,5457,5458}
1998/11/23 New 158-4991 Cat Mini Multi-Tool Now Available {1404}
1998/11/30 New Ignition Key Has Double Cut Edge {1553}
1998/11/30 A Special Instruction Is now Available To Install A New Cleaner Group And Precleaner {1051,1055}
1998/11/30 A Special Instruction Is now Available For Installing A Two-Way Pilot Valve {5496}
1998/11/30 A Special Instruction Is Now Available For Reinforcing Bottom Plates Of Stick Assemblies {6502}
1998/11/30 New Lowering Control Valve For Stick Cylinder lines Can Be Adjusted To Prevent Stick Flop {5067}
1998/11/30 Serviceable Parts For Monitor Group Has Changed {7490}
1998/11/30 Improved Process To Install Counterweight Decal {7581}
1998/11/30 Proper Flushing And Charging Of Air Conditioner Refrigerant System {7320}
1998/12/07 Illuminated Rocker Switch Assemblies Available As Serviced Components {7332,1435}
1998/12/07 Cooling System Thermostat To Be Replaced At 6,000 Hours {1355}
1998/12/07 Design Differences For Track Groups Requires New Information For Parts Manual And Operation & Maintenance Manual {4169,4170,4172}