1998/11/23 Caterpillar


Use 154-9740 Wire Connector Rework Kit For Solid Cable To Component Connections {1408}

Usage:


All Models

Warranty Category: Y

Features/Benefits

* Used to create a solid cable-to-component connection with an easily installed thumbscrew connector
* Works on any cable using DB-9 slotted-head, screw-type connector (similar to 7X-1425 Cable)
* No need to disconnect wires from connector (requires only cutting a slit in new grommet when spanning wire)
* No extra tools required - saves time and effort


154-9740 Housing Kit (cable not included)

Caterpillar Information System:

1998/11/23 Use 153-8538 Refrigerant Solvent For Air Conditioner Refrigerant Flushing Units {0708}
1998/11/23 Use 155-8795 Crankshaft Gauge To Determine Distortion {1202}
1998/11/23 Use 155-1536 Valve Recession Tool Kit To Determine Valve Wear {1103}
1998/11/23 Change In Location And Size Of Crankshaft Counterweight Sequence Number {1231,1202}
1998/11/23 Use FT2617 Bracket Assembly To Support Pumps When Removing Engine {1003}
1998/11/23 Larger Value Backup Resistors Are Used In Electronic Wiring Group To Limit PRV Solenoids For Main Pump And Swing Pump {1437}
1998/11/23 New Radio Requires Preventive Maintenance To Eliminate Battery Drain {7338}
1998/11/23 The Solenoid Valve Group Used For Low Flow Attachment Has Improved Performance {5051,5479}
1998/11/23 Be Sure Electronic Controllers Are Grounded At Machine Service Inspections {1408,1901,5702}
1998/11/23 New Check Valve Used For Refueling Pump {1295}
1998/11/23 New Seal Kits Prevent Hydraulic Cylinder Oil Leaks {5456,5457,5458}
1998/11/23 New Indicator Assembly In The Air Cleaner Group {1051,7452}
1998/11/23 Use 149-2872 Tooth Pin Remover Group For Removing Pins From Small Bucket Teeth {6822}
1998/11/23 New 158-4991 Cat Mini Multi-Tool Now Available {1404}
1998/11/30 New Ignition Key Has Double Cut Edge {1553}
1998/11/30 A Special Instruction Is now Available To Install A New Cleaner Group And Precleaner {1051,1055}
1998/11/30 A Special Instruction Is now Available For Installing A Two-Way Pilot Valve {5496}
1998/11/30 A Special Instruction Is Now Available For Reinforcing Bottom Plates Of Stick Assemblies {6502}
1998/11/30 New Lowering Control Valve For Stick Cylinder lines Can Be Adjusted To Prevent Stick Flop {5067}
1998/11/30 Serviceable Parts For Monitor Group Has Changed {7490}
1998/11/30 Improved Process To Install Counterweight Decal {7581}
1998/11/30 Proper Flushing And Charging Of Air Conditioner Refrigerant System {7320}
1998/12/07 Illuminated Rocker Switch Assemblies Available As Serviced Components {7332,1435}
1998/12/07 Cooling System Thermostat To Be Replaced At 6,000 Hours {1355}
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.