Vibration Damper and Pulley - Remove and Install
Show/hide table
工具 | 零件号 | 零件描述 | 数量 |
---|---|---|---|
A | - | 5/8 in-NF X 7 in 长导向螺栓 | 1 |
- 拆下螺栓 (1) 和垫圈。 安装工具 (A)。
- 拆下五条螺栓 (2) 和垫圈。 拆下曲轴减振器 (3)。
- 如果发动机配有前皮带轮,则拆下将皮带轮固定在减振器上的螺栓。
Show/hide table
图 1 | g00557582 |
典型示例 |
Show/hide table
工具 | 零件号 | 零件描述 | 数量 |
---|---|---|---|
A | - | 5/8 in-NF X 7 in 长导向螺栓 | 1 |
- 如果发动机配有前皮带轮,则安装将减振器固定到前皮带轮的螺栓。 拧紧螺栓至扭矩为
135 ± 15 N·m (100 ± 11 lb ft) 。Show/hide table图 2 g00557582 典型示例 - 安装工具 (A)。
- 安装曲轴减振器 (3)。
- 利用干净的机油轻轻润滑螺栓的螺纹。 安装五个螺栓 (2)。 拆下工具 (A) 然后安装螺栓 (1)。
Caterpillar Information System:
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers Joint Assembly for Water Line
G3408 and G3412 Engines Governor and Magneto Drive
3406E and 3456 Generator Set Engines Flywheel - Install
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers General Information
3054 and 3056 Industrial and Generator Set Engines Lubrication System
G3408 and G3412 Engines Turbocharger
Procedure for Replacing the Software for the Electronic Ignition System (EIS){1902} Procedure for Replacing the Software for the Electronic Ignition System (EIS){1902}
3054 and 3056 Industrial and Generator Set Engines Cooling System
G3606 and G3608 Engines Flywheel and Ring Gear - Remove and Install
3512 and 3516 EUI Engines and 784B, 785B, 789B and 793B Off-Highway Truck/Tractors Engine Oil Scavenge Pump
G3408 and G3412 Engines Water Temperature Regulator
3054 and 3056 Industrial and Generator Set Engines Engine Design
Caterpillar PRELUB® Diagnostics{1469} Caterpillar PRELUB® Diagnostics{1469}
3412E, C30 and C32 Marine Engines Auxiliary Water Pump - Remove
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers High Speed Coupling for Gearbox
3412E, C30 and C32 Marine Engines Auxiliary Water Pump - Install
3412E, C30 and C32 Marine Engines Auxiliary Water Pump - Disassemble
3412E and C30 Marine Engines Serial Number Plate
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers High Speed Coupling for Gearbox
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers Heat Exchanger
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers Control Panel (AC Power)
Control Console For CPS361 Pumper, Cement Battery Disconnect
G3606 and G3608 Engines Crankshaft Front Seal and Wear Sleeve - Remove
G3606 and G3608 Engines Crankshaft Front Seal and Wear Sleeve - Install