Heat Exchanger
Show/hide table
Illustration 1 | g00505700 |
G3408C and G3412C heat exchanger Bolt tightening sequence and dimension (A) |
Show/hide table
Illustration 2 | g00505810 |
G3508, G3512, and G3516 heat exchanger Bolt tightening sequence and dimension (A) |
Dimension (A) is measured and recorded in order to perform maintenance on the Heat Exchanger. See Operation and Maintenance Manual, SEBU7121, "Heat Exchanger - Clean" in order to perform the maintenance.
For G3408C and G3412C Engines, use the bolt tightening sequence from Illustration 1.
For G3500 Engines, use the bolt tightening sequence from Illustration 2.
Show/hide table
Maximum Torque for Bolts With Washers     | ||
Thread Size     | Torque     | |
25.4 mm (1.00 inch)     |
42 N·m (31 lb ft)     |
|
28.58 mm (1.125 inch)     |
84 N·m (62 lb ft)     |
|
38.1 mm (1.50 inch)     |
185 N·m (137 lb ft)     |
Caterpillar Information System:
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers High Speed Coupling for Gearbox
3412E and C30 Marine Engines Serial Number Plate
3412E, C30 and C32 Marine Engines Auxiliary Water Pump - Disassemble
3412E, C30 and C32 Marine Engines Auxiliary Water Pump - Install
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers High Speed Coupling for Gearbox
3412E, C30 and C32 Marine Engines Auxiliary Water Pump - Remove
Caterpillar PRELUB® Diagnostics{1469} Caterpillar PRELUB® Diagnostics{1469}
3408E and 3412E Engines for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers Joint Assembly for Water Line
G3408 and G3412 Engines Governor and Magneto Drive
3406E and 3456 Generator Set Engines Flywheel - Install
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers General Information
G3408C, G3412C, G3508, G3512 and G3516 Gas Engine Driven Chillers Control Panel (AC Power)
Control Console For CPS361 Pumper, Cement Battery Disconnect
G3606 and G3608 Engines Crankshaft Front Seal and Wear Sleeve - Remove
G3606 and G3608 Engines Crankshaft Front Seal and Wear Sleeve - Install
Control Console For CPS361 Pumper, Cement Engine Electronics
3406C (PEEC III) Truck Engines Compression Brake
3412E, C30 and C32 Marine Engines Auxiliary Water Pump - Assemble
G3408 and G3412 Engines Auxiliary Water Pump
G3606 and G3608 Engines Crankshaft Rear Seal - Remove
G3606 and G3608 Engines Crankshaft Rear Seal - Install
Control Console For CPS361 Pumper, Cement Purge System
G3408 and G3412 Engines Air Cleaner