Turbocharger - Remove
Removal Procedure
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products. Dispose of all fluids according to local regulations and mandates. |
- Remove bolts (2) and the washers.
Show/hide table
Illustration 1 | g00556372 |
Show/hide table
Illustration 2 | g00556374 |
Show/hide table
Illustration 3 | g00568970 |
- Remove bolt (7) and clamp (6) .
- Disconnect fitting (5) .
- Remove oil supply tube assembly (3) and the gasket.
- Disconnect hose (8) from the wastegate.
- Remove bolts (11) and the washers.
- Remove bolts (10) and the washers.
- Remove oil drain tube assembly (9), the O-ring seal, and the gasket.
- Remove nuts (4) .
- Remove compressor (16), housing (1), and cartridge (15) from the exhaust manifold. Remove gasket (14) .
- Loosen band clamps (12) and (13). Separate compressor (16), and housing (1) from cartridge (15) .
Caterpillar Information System:
3612 and 3616 Engines Priority Valve - Assemble
3612 and 3616 Engines Priority Valve - Disassemble
3406C (PEEC III) Truck Engines Basic Block
3500B Engines for Caterpillar Built Power Modules Flywheel Housing Cover
3612 and 3616 Engines Priority Valve - Install
3054 and 3056 Industrial and Generator Set Engines General Information
3406C (PEEC III) Truck Engines Cooling System
322B, 322B L, 325B and 325B L Excavators Travel Control - Straight Travel Pedal (If Equipped)
3406C (PEEC III) Truck Engines Lubrication System
3054 and 3056 Industrial and Generator Set Engines Electric Starting Motor
Generator Set Control Panel for Switchgear Conversion General Information
3612 and 3616 Engines Priority Valve - Remove
3176C Industrial Engine Turbocharger - Install
3406C (PEEC III) Truck Engines Electrical System
3054 and 3056 Industrial and Generator Set Engines Fuel System
G3606 and G3608 Engines Vibration Damper - Remove
G3408 and G3412 Engines Engine Oil Pan
3412E, C30 and C32 Marine Engines Heat Exchanger - Remove
797 Off-Highway Truck Steering System Steering Control Valve
G3408 and G3412 Engines Water Pump
Control Console For CPS361 Pumper, Cement Control Panel
3054 Engine for Caterpillar Built Machines Lifter Group - Remove and Install
SR4 HV and SR4B HV Generators Winding - Test
G3408 and G3412 Engines Vibration Damper