Information Plate
Show/hide table
Illustration 1 | g00102789 |
The Information Plate is on the valve cover or on the housing of the deaerator system. The following information is stamped on the Information Plate: engine's maximum altitude, horsepower, high idle, full load rpm, fuel settings and other information.
Caterpillar Information System:
3408E and 3412E Engines for Caterpillar Built Machines Unit Injector Sleeve - Install
3406E Truck Engines Electrical Ground Stud
Generator Set Control Panel for Switchgear Conversion Harness Code Mode
3408E and 3412E Engines for Caterpillar Built Machines Unit Injector Hydraulic Pump - Install
Generator Set Control Panel for Switchgear Conversion Normal Mode
3612 and 3616 Engines Engine Oil Filter Housings - Assemble
RA1.2, R1.4, R2.0, R2.2, R2.5, R2.7, R3.0, R4.5 and R5.5 Series Reduction Starting Motors Electric Starting Motor
Generator Set Control Panel for Switchgear Conversion Warning Operation
3612 and 3616 Engines Engine Oil Filter Housings - Disassemble
3408E and 3412E Engines for Caterpillar Built Machines Unit Injector Hydraulic Pump - Remove
3408E and 3412E Engines for Caterpillar Built Machines Unit Injector Sleeve - Remove
G3408 and G3412 Engines Air Starting Motor
3054 Engine Valve Mechanism Cover
3612 and 3616 Engines Engine Oil Filter Elements - Remove and Install
Generator Set Control Panel for Switchgear Conversion Service Mode
G3606 and G3608 Engines Engine Oil Pan - Remove
3054 and 3056 Industrial and Generator Set Engines Cylinder Head Valves
3054 Engine for Caterpillar Built Machines Crankshaft Main Bearings - Remove
3412E and C30 Marine Engines Walk-Around Inspection
G3606 and G3608 Engines Engine Oil Pan - Install
3054 Engine for Caterpillar Built Machines Engine Oil Relief Valve - Remove and Install
3054 and 3056 Industrial and Generator Set Engines Engine Oil Cooler - Install
Generator Set Control Panel for Switchgear Conversion Tattletale Mode
3608 Engine Engine Oil Pan - Disassemble