Turbocharger - Install
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Install oil drain tube (7) on the engine. Position the gasket and turbocharger (5) on top of the exhaust manifold and install four bolts (6) and the nuts.
Show/hide table
Illustration 1 | g00537495 |
Note: Check the condition of the gaskets and the O-ring seals. If the gaskets or the O-ring seals are worn or damaged, use new parts for replacement.
- Install the gasket and two bolts (3) that hold the oil drain tube to the turbocharger. Put the oil supply tube in position and install the gasket and two bolts (1) that hold the oil supply tube to the turbocharger. Tighten nut (4) .
Show/hide table
Illustration 2 | g00537468 |
- Install the clamp that holds the oil supply tube and the oil drain tube in position and install bolt (2) .
Caterpillar Information System:
3406E On-Highway Engine Rocker Arm - Disassemble
3306B Industrial Engine Turbocharger - Remove
3176C and 3196 Engines For Caterpillar Built Machines Crankshaft - Install
3176C and 3196 Engines For Caterpillar Built Machines Crankshaft - Remove
3176C and 3196 Engines For Caterpillar Built Machines Crankshaft Main Bearings - Install
3114, 3116, and 3126 Industrial and Generator Set Engines Fuel System - Prime
3176C and 3196 Engines For Caterpillar Built Machines Crankshaft Main Bearings - Remove
C-18 Truck Engines Compression Brake - Inspect/Adjust/Replace
3114, 3116, and 3126 Industrial and Generator Set Engines Engine Crankcase Breather - Clean
3406E On-Highway Engine Fuel Filter Base - Remove and Install
3176C and 3196 Engines For Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
3116 and 3126 Marine Engines Zinc Rods - Inspect/Replace
3406E On-Highway Engine Rocker Arm - Assemble
3176C and 3196 Industrial Engines Cylinder Head - Remove
3406C Engines for Caterpillar Built Machines Flywheel
3524B Engines for Off-Highway Trucks Excessive White Smoke
3406E On-Highway Engine Inlet and Exhaust Valve Springs - Remove and Install
3406E On-Highway Engine Rocker Arm and Shaft - Install
3406E and 3456 Engines for Caterpillar Built Machines Rocker Arm and Shaft - Remove
3304B and 3306B Engines for Caterpillar Built Machines Turbocharger - Disassemble
C-12 Truck Engine Cylinder Liner
3524B Engines for Off-Highway Trucks Too Much Vibration
3304B and 3306B Engines for Caterpillar Built Machines Turbocharger - Assemble
3406E On-Highway Engine Housing (Front) - Remove