Turbocharger - Remove
Removal Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Show/hide table
NOTICE |
---|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines. Dispose of all fluids according to local regulations and mandates. |
- Remove bolt (2) and the clamp that holds the oil supply tube and the oil drain tube in position.
Show/hide table
Illustration 1 | g00537468 |
- Remove two bolts (1) that hold the oil supply tube to the turbocharger. Remove two bolts (3) that hold the oil drain tube to the turbocharger.
- Loosen nut (4) and remove the oil supply tube from the engine.
- Loosen four bolts (6) and the nuts that hold turbocharger (5) to the exhaust manifold. Remove turbocharger (5) and the gasket from the exhaust manifold. Remove oil drain tube (7) from the engine and check the O-ring seal for damage. If the O-ring seal is worn or damaged, use a new part for replacement.
Show/hide table
Illustration 2 | g00537495 |
Caterpillar Information System:
3176C and 3196 Engines For Caterpillar Built Machines Crankshaft - Install
3176C and 3196 Engines For Caterpillar Built Machines Crankshaft - Remove
3176C and 3196 Engines For Caterpillar Built Machines Crankshaft Main Bearings - Install
3114, 3116, and 3126 Industrial and Generator Set Engines Fuel System - Prime
3176C and 3196 Engines For Caterpillar Built Machines Crankshaft Main Bearings - Remove
C-18 Truck Engines Compression Brake - Inspect/Adjust/Replace
3114, 3116, and 3126 Industrial and Generator Set Engines Engine Crankcase Breather - Clean
3406E On-Highway Engine Fuel Filter Base - Remove and Install
3176C and 3196 Engines For Caterpillar Built Machines Pistons and Connecting Rods - Disassemble
3116 and 3126 Marine Engines Zinc Rods - Inspect/Replace
3406C (PEEC III) Truck Engines General Information
3524B Engines for Off-Highway Trucks ECM Will Not Communicate with Other Systems or Display Modules
3406E On-Highway Engine Rocker Arm - Disassemble
3306B Industrial Engine Turbocharger - Install
3406E On-Highway Engine Rocker Arm - Assemble
3176C and 3196 Industrial Engines Cylinder Head - Remove
3406C Engines for Caterpillar Built Machines Flywheel
3524B Engines for Off-Highway Trucks Excessive White Smoke
3406E On-Highway Engine Inlet and Exhaust Valve Springs - Remove and Install
3406E On-Highway Engine Rocker Arm and Shaft - Install
3406E and 3456 Engines for Caterpillar Built Machines Rocker Arm and Shaft - Remove
3304B and 3306B Engines for Caterpillar Built Machines Turbocharger - Disassemble
C-12 Truck Engine Cylinder Liner
3524B Engines for Off-Highway Trucks Too Much Vibration