Tachometer Drive - Remove and Install
Removal Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
- Remove the two bolts and clamps that hold tachometer drive (1) in position on the rear of the governor housing.
Show/hide table
Illustration 1 | g00515684 |
- Remove tachometer drive (1) and coupling (3) from the governor housing. Remove O-ring seal (2) from tachometer drive (1) .
Installation Procedure
Show/hide table
NOTICE |
---|
Keep all parts clean from contaminants. Contaminants may cause rapid wear and shortened component life. |
Note: Check the condition of the O-ring seal. If the O-ring seal is worn or damaged, use a new part for replacement.
- Install O-ring seal (2) on tachometer drive (1). Put tachometer drive (1) in position on the governor housing.
Show/hide table
Illustration 2 | g00515684 |
- Make sure that coupling (3) and tachometer drive (1) are engaged and install the two bolts that hold tachometer drive (1) to the governor housing. Tighten the bolts to a torque of 11 ± 3 N·m (97 ± 27 lb in).
Caterpillar Information System:
3176C and 3196 Engines For Caterpillar Built Machines Rocker Shaft and Pushrod - Install
3406E On-Highway Engine Flywheel - Install
3176C and 3196 Engines For Caterpillar Built Machines Rocker Shaft and Pushrod - Remove
3176C and 3196 Engines For Caterpillar Built Machines Valve Mechanism Cover Base - Remove and Install
3306B Industrial Engine Service Meter - Remove and Install
3406E On-Highway Engine Flywheel - Remove
3176C and 3196 Engines For Caterpillar Built Machines Valve Mechanism Cover - Remove and Install
3406E On-Highway Engine Crankshaft - Install
G3300 Engines Engine Oil and Filter - Change
G3300 Engines Engine Oil Sample - Obtain
3176C and 3196 Engines For Caterpillar Built Machines Accessory Drive - Install
3606 and 3608 Engines Camshaft
3176C and 3196 Engines For Caterpillar Built Machines Lifter Group - Remove and Install
3406E On-Highway Engine Crankshaft Rear Seal - Remove
3304B and 3306B Engines for Caterpillar Built Machines Vibration Damper and Pulley - Remove and Install
3406E and 3456 Engines for Caterpillar Built Machines Crankshaft Rear Seal - Install
3176C and 3196 Engines For Caterpillar Built Machines Water Outlet Manifold - Remove
3176C and 3196 Engines For Caterpillar Built Machines Water Outlet Manifold - Install
3176C and 3196 Engines For Caterpillar Built Machines Inlet Manifold - Remove
3176C and 3196 Engines For Caterpillar Built Machines Inlet Manifold - Install
3406E On-Highway Engine Gear Group (Front) - Remove
3406E On-Highway Engine Engine Oil Pan - Remove and Install
3612 and 3616 Engines Manual Valve Group (Cylinder Pressure)
3116 and 3126 Marine Engines Refill Capacities