- Asphalt Paver
- AP655F (S/N: 4521-UP; P651-UP; 6551-UP; MH61-UP; 4791-UP)
- AP655F L (S/N: AC61-UP)
Reference: Refer to Specifications, SENR3130, "Torque Specifications"
Do not operate or work on this product unless you have read and understood the instruction and warnings in the relevant Operation and Maintenance Manuals and relevant service literature. Failure to follow the instructions or heed the warnings could result in injury or death. Proper care is your responsibility. |
A new 578-9055 Stopper Kit is available to be used on the machine installed with canopy. The new stopper kit avoids a possibility of interference between propel lever and canopy structure, once the canopy is being lowered for transportation. The new kit is available as a service kit and can be ordered through the part system.
The installation of the kit requires modification in the existing structure, refer to the instruction below for detailed process.
Note: Installation of the stopper kit will increase the shipping height of the machine. Consult the local regulations for shipping height requirements before performing the rework.
Illustration 1 | g06408195 |
View of stopper kit (1) (2) (3) (4) (5) (A) Location of the Pad (B) Location of the Bolt Dimension (C) Location of the Hard Washer |
Required Parts for Part Number 578-9055 Stopper Kit | |||
---|---|---|---|
Item | Qty | Part Number | Part Name |
1 | 2 | Hard Washer | |
2 | 2 | Pad | |
3 | 4 | Hard Washer | |
4 | 4 | Bolt | |
5 | 2 | Bolt |
- Remove and discard the old bolts and washers.
Use Illustration 2 to install pad (2) with two hard washers (3) and two bolts (4). Tighten two bolts (4).
Repeat Step 1 for the other side.
Show/hide tableIllustration 3 g06408415 Location of a new hole
(D1)66.6 mm (2.62 inch)
(D2)30.8 mm (1.21 inch)
(D3)22.5 mm (0.89 inch) DiameterNote: Recommend drilling a pilot hole first.
- Use dimensions (D1) and (D2) in Illustration 3 to drill a hole diameter (D3) on the rear canopy leg.
Repeat Step 2 for the other side of the rear canopy leg.
Show/hide tableIllustration 4 g06408379 Location of the hard washer
(1)198-4776 Hard Washer
(C) Location of the Hard Washer - Remove the nut and the bumper from the canopy. Retain the nut and the bumper.
Install hard washer (1) onto the bumper. Use Illustration 4 to install washer (1) and the bumper to the canopy with the nut. Tighten the nut.
Show/hide tableIllustration 5 g06408429 Location of the bolt dimension
(5)8T-4194 Bolt
(B) Location of the Bolt Dimension
(D4)45 mm (1.8 inch) - Remove and discard the existing bolt.
Use Illustration 5 to install bolt (5). Adjust bolt (5) to dimension (D4).
Illustration 2 | g06408358 |
Location of the pad (2) (3) (4) (A) Location of Pad |
Note: Do not remove or discard the old pad.