Cylinder Head Grounding Stud - Inspect/Clean/Tighten
Show/hide table
| |
| 图 1 | g00427181 |
|
缸盖接地螺柱 | |
检查原设备制造厂线束连接和状况是否良好。
气缸盖接地螺栓必须具备连接到蓄电池的接地线。 每一次换机油时要拧紧气缸盖接地螺栓。 接地线和接地带应共同连接到发动机接地点。 所有接地点必须紧固和无腐蚀现象。
- 用干净的布清洁气缸盖接地螺栓及气缸盖接地带端子。
- 如果连接处被腐蚀，使用烘焙苏打和水的溶液清洁连接处。
- 保持气缸盖接地螺栓和接地带清洁，并用多用途含钼锂基润滑脂(MPGM)或石油冻涂覆。
Caterpillar Information System:
3512 Industrial Engine Engine Description
3126E and 3126B Commercial and Truck Engines Belt Tensioner - Inspect - If Equipped
3126E and 3126B Commercial and Truck Engines Belt - Inspect
3512 Industrial Engine Engine Mounts - Check
3512 Industrial Engine Actuator Control Linkage - Lubricate
3512 Industrial Engine Maintenance Recommendations
3408C, 3412, 3412C, and 3412D High Performance Marine Engines Engine Rating Definitions
3034 Engine for Caterpillar Built Machines Flywheel
Replacement Of The Aftercooler Group On 3606 And 3608 Engines With The 7E-3100 Treated Water Aftercooler Group {1063} Replacement Of The Aftercooler Group On 3606 And 3608 Engines With The 7E-3100 Treated Water Aftercooler Group {1063}
3126 Truck Engine (Military) Electrical System
3512 Industrial Engine Engine Oil and Filter - Change
3512 Industrial Engine Fuel System Secondary Filter - Replace
3512 Industrial Engine Before Starting Engine
3126 HEUI Industrial Engine Electronic Control System
C-10 and C-12 Truck Engines Compression Brake
3512 Industrial Engine Cold Weather Starting
3126E and 3126B Commercial and Truck Engines Engine Air Cleaner Element - Clean/Replace
3126E and 3126B Commercial and Truck Engines Engine Crankcase Breather - Clean
3512 Industrial Engine Starting the Engine
3512 Industrial Engine After Starting Engine
3512 Industrial Engine Emergency Stopping
3126E and 3126B Commercial and Truck Engines Engine Oil Level - Check
3512 Industrial Engine Manual Stop Procedure
3176C and 3196 Engines for Caterpillar Built Machines Rear Power Take-Off (RPTO)