Engine Oil Level - Check
Show/hide table
热油和热的部件可能会导致人员受伤。 不要让热的机油和部件接触皮肤。 |
Show/hide table
图 1 | g01076429 |
(1) 机油加注口盖
(2) 油尺 |
Show/hide table
图 2 | g00110310 |
(Y) "加(ADD)"标记
(X) "满(FULL)"标记 |
Show/hide table
注意 |
---|
在发动机停机时进行该保养。 |
注: 进行保养之前,至少让出10分钟时间不要运转发动机,以使发动机机油能够流回到油底壳。
- 保持机油油位在油尺 (1)的"加(ADD)"标记 (Y)和"满(FULL)"标记 (X)之间。 向曲轴箱加注加油时,不要超过"满(FULL)"标记 (X)。
Show/hide table
注意 如果曲轴箱中注油超过油尺上的"满(FULL)"标记,发动机可能因此而损坏。
曲轴箱注油过量能使曲轴浸在机油中。 这将降低发出的功率,还迫使空气泡进入机油中。 这些气泡(泡沫)会造成下列问题: 降低机油的润滑能力, 降低机油压力, 活塞冷却不充分, 机油从曲轴箱呼吸器处涌出 and 过多的机油消耗量。
机油的过度消耗将在活塞上和燃烧室中形成积碳。 燃烧室中的积碳会导致下列问题: 气门形成冲蚀槽, 活塞环后积碳堆积 and 缸套磨损。
如果机油油位高于油尺上的"满(FULL)"标记,立即放掉一些机油。
- 如有必要,取下加注口盖 (2),添加机油。 有关补充用冷却液添加剂(SCA)的正确浓度,请参阅专门出版物, SEBU6251, "卡特彼勒商用柴油发动机用液建议". 向曲轴箱中加注加油时,不要超过油尺上的"满(FULL)"标记 (X)。 清洁发动机机油加注口盖。 安装机油滤清器加注口盖。
- 记下加注的油量。 为了进行下一次机油采样和分析,记录应包括自上一次采样后添加的总的机油量。 这将有助于提供最准确的机油分析。
Caterpillar Information System:
3512 Industrial Engine Emergency Stopping
3512 Industrial Engine After Starting Engine
3512 Industrial Engine Starting the Engine
3126E and 3126B Commercial and Truck Engines Engine Crankcase Breather - Clean
3126E and 3126B Commercial and Truck Engines Engine Air Cleaner Element - Clean/Replace
3512 Industrial Engine Cold Weather Starting
C-10 and C-12 Truck Engines Compression Brake
3126 HEUI Industrial Engine Electronic Control System
3512 Industrial Engine Before Starting Engine
3126E and 3126B Commercial and Truck Engines Cylinder Head Grounding Stud - Inspect/Clean/Tighten
3512 Industrial Engine Engine Description
3126E and 3126B Commercial and Truck Engines Belt Tensioner - Inspect - If Equipped
3512 Industrial Engine Manual Stop Procedure
3176C and 3196 Engines for Caterpillar Built Machines Rear Power Take-Off (RPTO)
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Fuel Injection Nozzles
3176C Engine Electronic Control System
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Fuel Injection Pump
C-10 and C-12 Truck Engines Fuel System
3408B and 3412C Generator Set Engines General Information
3126E and 3126B Commercial and Truck Engines Fuel System - Prime
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Fuel Transfer Pump
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Gear Group (Front)
3126 HEUI Industrial Engine Lubrication System
3406E Truck Engine Fuel Filter Base