Flywheel
Show/hide table
 | |
| Illustration 1 | g00719607 |
(1) The maximum temperature for heating the flywheel ring gear for installation ... 250°C (480°F)
(2) Tighten the flywheel bolts to the following torque. ... 100 N·m (74 lb ft)
Refer to Testing and Adjusting, "Flywheel - Inspect".
Caterpillar Information System:
Replacement Of The Aftercooler Group On 3606 And 3608 Engines With The 7E-3100 Treated Water Aftercooler Group {1063} Replacement Of The Aftercooler Group On 3606 And 3608 Engines With The 7E-3100 Treated Water Aftercooler Group {1063}
3126 Truck Engine (Military) Electrical System
3512 Industrial Engine Engine Oil and Filter - Change
3512 Industrial Engine Fuel System Secondary Filter - Replace
3126B Truck Engine Refill Capacities
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Flywheel
C15 Petroleum Generator Set Engines Electrical System
3126 Truck Engine (Military) Air Inlet and Exhaust System
3512 Industrial Engine Engine Oil Level - Check
3126 HEUI Industrial Engine Basic Block
3500B Locomotive Engines Engine Air Precleaner - Clean
3408C, 3412, 3412C, and 3412D High Performance Marine Engines Permanent Fault Logging
3408C, 3412, 3412C, and 3412D High Performance Marine Engines Engine Rating Definitions
3512 Industrial Engine Maintenance Recommendations
3512 Industrial Engine Actuator Control Linkage - Lubricate
3512 Industrial Engine Engine Mounts - Check
3126E and 3126B Commercial and Truck Engines Belt - Inspect
3126E and 3126B Commercial and Truck Engines Belt Tensioner - Inspect - If Equipped
3512 Industrial Engine Engine Description
3126E and 3126B Commercial and Truck Engines Cylinder Head Grounding Stud - Inspect/Clean/Tighten
3512 Industrial Engine Before Starting Engine
3126 HEUI Industrial Engine Electronic Control System
C-10 and C-12 Truck Engines Compression Brake
3512 Industrial Engine Cold Weather Starting