Flywheel
Show/hide table
Illustration 1 | g00691436 |
(1) Flywheel
(2) Flywheel bolts
- Tighten the flywheel bolts to the following torque. ... 73 N·m (54 lb ft)
(3) Ring gear
- The maximum temperature for heating the flywheel ring gear for installation ... 150°C (302°F)
Note: When the backplate is installed, place a bead of 8T-9022 Silicone Gasket around the bolt holes for the backplate in the cylinder block.
Flywheel Runout
Face Runout
Show/hide table
Illustration 2 | g00295955 |
Measure the Face Runout. |
Maximum permissible face runout of the flywheel ... 0.20 mm (0.008 inch)
Refer to Testing and Adjusting, "Flywheel - Inspect".
Outside Diameter Runout
Show/hide table
Illustration 3 | g00295956 |
Measure the Outside Diameter Runout. |
Maximum permissible outside diameter runout of the flywheel ... 0.20 mm (0.008 inch)
Refer to Testing and Adjusting, "Flywheel - Inspect".
Caterpillar Information System:
C15 Petroleum Generator Set Engines Electrical System
3126 Truck Engine (Military) Air Inlet and Exhaust System
3512 Industrial Engine Engine Oil Level - Check
3126 HEUI Industrial Engine Basic Block
3500B Locomotive Engines Engine Air Precleaner - Clean
3408C, 3412, 3412C, and 3412D High Performance Marine Engines Permanent Fault Logging
3126 Truck Engine (Military) Cooling System
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Fan Drive
3406E and 3456 Engines for Caterpillar Built Machines Glossary of Electronic Control Terms
3406E and 3456 Industrial Engines General Information
3176C and 3196 Engines for Caterpillar Built Machines Basic Engine
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Engine Oil Pump
3126B Truck Engine Refill Capacities
3512 Industrial Engine Fuel System Secondary Filter - Replace
3512 Industrial Engine Engine Oil and Filter - Change
3126 Truck Engine (Military) Electrical System
Replacement Of The Aftercooler Group On 3606 And 3608 Engines With The 7E-3100 Treated Water Aftercooler Group {1063} Replacement Of The Aftercooler Group On 3606 And 3608 Engines With The 7E-3100 Treated Water Aftercooler Group {1063}
3034 Engine for Caterpillar Built Machines Flywheel
3408C, 3412, 3412C, and 3412D High Performance Marine Engines Engine Rating Definitions
3512 Industrial Engine Maintenance Recommendations
3512 Industrial Engine Actuator Control Linkage - Lubricate
3512 Industrial Engine Engine Mounts - Check
3126E and 3126B Commercial and Truck Engines Belt - Inspect
3126E and 3126B Commercial and Truck Engines Belt Tensioner - Inspect - If Equipped