Engine Air Cleaner Element (Single Element) - Replace
Perform the Operation and Maintenance Manual, "Engine Air Cleaner Service Indicator-Inspect" procedure and perform the Operation and Maintenance Manual, "Engine Air Precleaner Check/Clean" procedure (if equipped) before performing the following procedure.
Show/hide table
NOTICE |
---|
Never run the engine without an air cleaner element installed. Never run the engine with a damaged air cleaner element. Do not use air cleaner elements with damaged pleats, gaskets or seals. Dirt entering the engine causes premature wear and damage to engine components. Air cleaner elements help to prevent airborne debris from entering the air inlet. |
Show/hide table
NOTICE |
---|
Never service the air cleaner element with the engine running since this will allow dirt to enter the engine. |
Show/hide table
Illustration 1 | g00422568 |
Show/hide table
Illustration 2 | g00310664 |
- Remove the air cleaner cover (1) and remove the element (2).
- Seal the turbocharger air inlet (3) so that debris cannot enter the air inlet. Tape or a clean cloth can be used to cover the opening.
- Clean the inside of the air cleaner cover. Clean the body that holds the air cleaner element.
- Inspect the replacement element for the following items:damage, dirt and debris.
- Remove the seal from the opening of the turbocharger inlet.
- Install a clean, undamaged element.
- Install the air cleaner cover (1).
- Reset the service indicator.
Caterpillar Information System:
3406E and 3456 Industrial Engines Magnetic Pickups - Clean/Inspect
Installation Instructions For The 160-9874 Gasket Kit {1213, 7555} Installation Instructions For The 160-9874 Gasket Kit {1213, 7555}
3126E and 3126B Commercial and Truck Engines Stopping the Engine
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Cylinder Block
631E Series II Wheel Tractor-Scrapers Fuel Injection Timing - Check
3406E Generator Set Engines Engine Speed/Timing Sensors - Check/Clean/Calibrate
3176C and 3196 Engines for Caterpillar Built Machines Lubrication System
3126 Truck Engine (Military) Electronic Control System Components
3512 Industrial Engine Fuel System - Prime
3512 Industrial Engine Cooling System Coolant (ELC) - Change
3406E and 3456 Industrial Engines Cylinder Head Grounding Stud - Inspect/Clean/Tighten
3512 Industrial Engine Cooling System Coolant (DEAC) - Change
3126E and 3126B Commercial and Truck Engines Fuel Related Components in Cold Weather
3176C and 3196 Engines for Caterpillar Built Machines Cooling System
3126 Truck Engine (Military) Lubrication System
554 Forwarder and 574 Forwarder Decommissioning and Disposal
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Cylinder Head Valves
3406E and 3456 Industrial Engines General Information
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Engine Oil Relief Valve
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Engine Oil Pan
3500B Locomotive Engines Cooling System Coolant (DEAC) - Change
3126E and 3126B Commercial and Truck Engines Fuel and the Effect from Cold Weather
3003, 3013, 3014 and 3024 Engines for Caterpillar Built Machines Engine Oil Pressure Switch
3500B Locomotive Engines Cooling System Coolant (ELC) - Change