 |
|
Diesel engine exhaust contains products of combustion which may cause personal injury. Always start and operate the engine in a well ventilated area, and, if in an enclosed area, vent the exhaust to the outside. |
|
|
Personal injury can result from rotating and moving parts. Stay clear of all rotating and moving parts. Never attempt adjustments while the machine is moving or the engine is running unless otherwise specified. The machine must be parked on a level surface and the engine stopped. Attach a "Do Not Operate" or similar warning tag to the start switch and controls before servicing, repairing, or making adjustments to the machine. |
|
|
Personal injury or death can result from sudden machine movement. Sudden movement of the machine can cause injury to persons on or near the machine. To prevent injury or death, make sure that the area around the machine is clear of personnel and obstructions before operating the machine. |
|
|
Personal injury can result from hydraulic oil pressure and hot oil. Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system. Make sure all of the attachments have been lowered, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. |
| NOTICE |
|---|
|
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the machine. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids. Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide", for tools and supplies suitable to collect and contain fluids in Caterpillar machines. Dispose of all fluids according to local regulations and mandates. |
- Drive the machine to a smooth, horizontal surface.
Show/hide table
Illustration 1 g06167947 - Move propel lever (1) to the NEUTRAL position.
- Move parking brake switch (2) to the ON position.
- Place the engine in ECO mode or low idle.
- Select "Main Menu" (3) on the machine display.
- Select "Machine Setup" (4).
Show/hide table
Illustration 3 g06148261 - Select "Engine Spd Sw" (5).
Show/hide table
Illustration 4 g06148286 - Select "ECO" (6) or "Low" (7).
Show/hide table
Illustration 2 g06148038 Show/hide table
Illustration 5 g06144108 - Move engine start switch (8) to the OFF position.
Show/hide table
Illustration 6 g06174258 - Unlock latch (9) and open rear engine compartment door (10) on the left side of the machine.
Show/hide table
Illustration 7 g06174231 - Slowly remove cap (11) from the hydraulic tank. Listen for escaping pressure. The cap is not vented.
- Reinstall cap (11).
- If the hydraulic tank was pressurized, go to Step 10. If the hydraulic tank was not pressurized, go to Step 13.
Show/hide table
Illustration 8 g06174262 - Unlock latch (12) and open front engine compartment door (13) on the left side of the machine.
Show/hide table
Illustration 9 g06174239 - Replace breather (14).
- Close front engine compartment door (13) and secure latch (12).
- Close rear engine compartment door (10) and secure latch (9).
