Swing Drive Oil - Change
- Remove the access cover that is located under the machine, near the swing gear.
Show/hide table
Illustration 1 g06174250 - Remove drain hose (1) from the frame. Face the end of the hose toward the container.
Note: Refer to Operation and Maintenance Manual, "General Hazard Information" for information that pertains to containing fluid spillage.
- Loosen the drain valve (2). Drain the oil into a suitable container.
Note: Dispose of drained fluids according to local regulations.
- Tighten the drain valve.
- Return the end of the drain hose to the frame. Make sure that the end of the hose is facing upward.
- Tighten the drain valve.
- Return the end of the drain hose to the upper frame. Make sure that the end of the hose is facing upward.
- Install the access cover.
- Remove the dipstick (3).
- Add the specified quantity of oil through the dipstick tube. See Operation and Maintenance, "Capacities (Refill)".
Show/hide table
Illustration 3 g03403841 - Make sure that the oil level is maintained to the "Full" mark on the dipstick.
- Check the oil that has been drained for metal chips or metal particles. Consult your authorized dealer if any metal chips or metal particles are found.
Note: Dispose of drained materials according to local regulations.
Show/hide table
Illustration 2 | g06174255 |
Caterpillar Information System:
2384D 2484D Knuckle Boom Loader Hydraulic System Oil Sample - Obtain
559D, 579D Knuckleboom Loader Hydraulic System Oil Level - Check
3516E Engine for 994K Wheel Loaders Turbocharger Turbine Temperature Is High
3512C Engines for 785C Off-Highway Trucks with Dynamic Gas Blending Exhaust Has Excessive Black Smoke
559D, 579D Knuckleboom Loader Hydraulic System Oil Filter (Case Drain) - Replace
CD10 Asphalt Compactor Propel Systems System Pressure - Release
CD10 Vibratory Asphalt Compactor Machine Systems Visual Inspection
CD10 Vibratory Asphalt Compactor Machine Systems Machine Preparation for Troubleshooting
3512C Engines for 785C Off-Highway Trucks with Dynamic Gas Blending Acceleration Is Poor or Throttle Response Is Poor
New Alternator Group and Support Bracket are Now Used on Certain 770G and 772G Off-Highway Trucks {1207, 1357, 1358, 1397, 1405, 1802, 7168} New Alternator Group and Support Bracket are Now Used on Certain 770G and 772G Off-Highway Trucks {1207, 1357, 1358, 1397, 1405, 1802, 7168}
785G Off-Highway Truck Machines Systems Electronic Control Module (Power Train) - Remove and Install
426F2 Back Hoe Loader Machine System Sliding Frame and Bearing - Install
785G Off-Highway Truck Machines Systems Electronic Control Module (Machine) - Remove and Install
CD10 Asphalt Compactor Propel Systems Hydraulic Oil Contamination - Test
559D, 579D Knuckleboom Loader Reference Material
CD10 Asphalt Compactor Propel Systems Relief Valve (Charge) - Test and Adjust - Split Drum
CD10 Vibratory Asphalt Compactor Machine Systems Relief Valve (Charge) - Test and Adjust - Solid Drum
CD10 Vibratory Asphalt Compactor Machine Systems Steering Pump Flow - Test
426F2 Back Hoe Loader Machine System Stabilizer - Remove and Install
426F2 Backhoe Loader Power Train Tire and Rim (Rear) - Remove and Install
New Software for CB4x0 Grade Control Display Is Now Available For Certain Cat® Products {7620} New Software for CB4x0 Grade Control Display Is Now Available For Certain Cat® Products {7620}
773E Off-Highway Truck Engine Supplement Fuel Priming Pump - Remove and Install
773E Off-Highway Truck Engine Supplement Fuel Filter (Primary) and Fuel Filter Base - Remove and Install
Parking Brake Lip Seals Are Now Available Individually on Certain C Series Wheel Feller Bunchers {3275, 3276, 3277, 4267, 7555} Parking Brake Lip Seals Are Now Available Individually on Certain C Series Wheel Feller Bunchers {3275, 3276, 3277, 4267, 7555}