CB10 Vibratory Asphalt Compactor Machine Systems Caterpillar

Position Sensor (Steering) - Calibrate

Usage:

CB10 5B4

Show/hide table

Diesel engine exhaust contains products of combustion which may cause personal injury.

Always start and operate the engine in a well ventilated area, and, if in an enclosed area, vent the exhaust to the outside.

Show/hide table

Personal injury can result from rotating and moving parts. Stay clear of all rotating and moving parts.
Never attempt adjustments while the machine is moving or the engine is running unless otherwise specified.
The machine must be parked on a level surface and the engine stopped.

Attach a "Do Not Operate" or similar warning tag to the start switch and controls before servicing, repairing, or making adjustments to the machine.

Show/hide table

Personal injury or death can result from sudden machine movement.
Sudden movement of the machine can cause injury to persons on or near the machine.

To prevent injury or death, make sure that the area around the machine is clear of personnel and obstructions before operating the machine.

Show/hide table

Table 1
Required Tools
Tool	Part Number	Description	Qty
A	N/A	Laptop Computer with Plus+1^TM Software	1
B⁽¹⁾	317-7485	Communication Adapter	1
C⁽¹⁾	370-4617	Cable As	1
D⁽¹⁾	457-6114	Cable As	1

Show/hide table

⁽¹⁾	Tool (B), Tool (C), and Tool (D) are part of the 466-6258 Communication Adapter Gp.

Drive the machine to a smooth, horizontal surface.
Show/hide table

Illustration 1 g06144094
Move propel lever (1) to the NEUTRAL position.
Move parking brake switch (2) to the ON position.
Place the engine in ECO mode or low idle.
1. Select "Main Menu" (3) on the machine display.
2. Select "Machine Setup" (4).
  Show/hide table
  
  Illustration 3 g06148261
3. Select "Engine Spd Sw" (5).
  Show/hide table
  
  Illustration 4 g06148286
4. Select "ECO" (6) or "Low" (7).
Show/hide table

Illustration 5 g06144108
Move engine start switch (8) to the OFF position.
Show/hide table

Illustration 6 g06144759
Assemble the tooling. Connect Tool (C) and Tool (D) to Tool (B). Connect Tool (D) to diagnostic connector (9). Connect Tool (C) to USB port on Tool (A).
Move engine start switch (8) to the START position. Release the switch when the engine starts.
Place the engine in ECO mode or low idle.
Launch the Plus+1^TM program on the computer to enable the vibe test mode.
Note: If usingPlus+1^TM for the first time, perform the tasks in the Communication and Connections Wizard. This wizard allows the Windows^® operating system to recognize the USB device. Follow the on-screen instructions.
Show/hide table

Illustration 7 g06152425
Click "Calibrations" icon (10).
Clear any open "Active Codes".
Click "Steering Sensors" (11).
Click "Front" (12) to calibrate the steering.
Click "Rear" (13) to calibrate the offset, if equipped.
Show/hide table

Illustration 8 g06152451
Read and understand the safety requirements outlined on the warning page. Click "OK" icon (14).
Follow the steps on the Plus+1^TM program to calibrate the steering sensor position.
Move parking brake switch (2) to the ON position.
Place the engine in ECO mode or low idle.
Move engine start switch (8) to the OFF position.
Remove tooling from diagnostic connector (9).