Hydraulic Actuator Position Sensor Calibration
安装时，必须预设所有旋转传感器。 应当采用以下程序正确标定液压执行器位置传感器。
- 松开挠性连接器上带连杆一侧的内六角螺钉。 确保挠性连接器上带传感器一侧的内六角螺钉紧固。
- 转动对应传感器，以获得 1.7 ± 0.1 VDC 的传感器电压。 利用下表正确设定每个传感器。
Show/hide table
表 1 阀 阀位 J-盒端子位置 燃油 闭合 841 废气旁通阀 闭合 851 阻风门 断开 846
- 将传感器设定到 1.7 VDC 后，上紧内六角螺钉。
- 废气旁通阀和阻风门的高电压读数应当大于 8.0 VDC。
注: 燃油执行器反馈的顶端将约为 5 到 6 VDC。
- 将连杆从全开位置移到全闭位置。 检查设定点的再现性。
- 如果对测试的再现性不满意，则重复步骤 1 到 4。
Caterpillar Information System:
G3606 and G3608 Engines Pressure Relief Valve Setting
3618 Engine Crankshaft Seals
3508, 3512 and 3516 Engines Fuel System
3406E Truck Engines Engine Vibration Troubleshooting
3054 Engine Electrical System
G3606 and G3608 Engines Choke Trim
PM3412C Power Modules Model View Illustrations
3054 Engine Air Inlet and Exhaust System
3406C (PEEC III) Truck Engines Brakesaver Troubleshooting
3406E Generator Set Engines Generator Identification
G3612 and G3616 Engines Wastegate Actuator Adjustment
G3500 Engines Product Description
Electronic Modular Control Panel II (EMCP II) For MUI Engines Engine/Generator Programming OP5
3406E Truck Engines Electronic Control System
G3500 Engines Ignition Systems
G3300 Engines Electrical System
3618 Engine Engine Design
3406E, C-10 and C-12 Truck Engines Fuel System Primary Filter - Clean/Replace
G3606 and G3608 Engines Cooling System
G3612 and G3616 Engines Manual Barring Group - 50:1 Reduction
3512 Industrial Engine Extended Life Coolant (ELC)
3618 Engine Troubleshooting
3512 Industrial Engine Extended Life Coolant (ELC) Cooling System Maintenance
SPS342 Skid Mounted Pumper S·O·S Services Coolant Analysis