Digital Sensor
Show/hide table
 | |
| Illustration 1 | g00289713 |
Install the sensor into the flywheel housing until the tip of the sensor contacts one of the gear teeth. Then unscrew the sensor for 1/2 to 3/4 of a turn (180 to 270 degrees). Tighten the locknut to the specified torque.
(1) Sensor assembly
- Torque ... 25 ± 5 N·m (18 ± 4 lb ft)
- Clearance between the sensor and the gear tooth ... 0.89 ± 0.15 mm (0.035 ± 0.006 inch)
Caterpillar Information System:
3406C (PEEC III) Truck Engine Alternator
G3612 and G3616 Engines Speed Sensor
3618 Engine Auxiliary Water Pump
3208 Marine Engine Engine Oil and Filter - Change
3612 and 3616 Engines Air Cleaner Adapter
G3612 and G3616 Engines Detonation Sensor
G3612 and G3616 Engines Pressure Sensor
G3612 and G3616 Engines Pressure Sensor
3618 Engine Vibration Damper - Single
120H, 12H, 135H, 140H, 143H, 160H and 163H Motor Graders Glossary of Electrical Terms
3618 Engine Housing (Front)
3412C Generator Set Full Load Operation
3618 Engine Engine Lifting Bracket
3406E Truck Engine Engine to Transmission Adapter
3406E Truck Engine Fan Drive
3618 Engine Flywheel
3618 Engine Camshaft
3408C, 3412, 3412C, and 3412D High Performance Marine Engines Reference Material
3406E Truck Engine Atmospheric Pressure Sensor
G3606 and G3608 Engines Air Lines - Choke
3612 and 3616 Engines Valve Mechanism
SPS342 Skid Mounted Pumper Fuel System - Prime
3618 Engine Cylinder Head, Valves, Valve Springs and Valve Seat Inserts
3406E Truck Engines General Information