Always check the condition of the seat belt and the condition of the mounting hardware before you operate the machine.
Each operator should make sure that the correct adjustments are made to insure a correct fit of the harness.
Illustration 1 | g03453756 |
Place each arm under the adjacent shoulder strap.
Illustration 2 | g03453778 |
Pull upward on the orange tabs to loosen belt.
Illustration 3 | g03453805 |
Buckle the lap belt. Fasten the seat belt catch into the buckle . Make sure that the seat belt is placed low across the lap of the operator.
Illustration 4 | g03453821 |
Pull black strap ends to snug belt across hips and pelvis. The buckle should be centered and the shoulder belts straight.
Note: If buckle rides up tighten lab belt. Make sure that the seat belt is placed low across the lap of the operator.
- Push release button on buckle. This action will release the lap belt.
- Remove arms from under adjacent shoulder straps.
Illustration 5 | g03453859 |
(1) Strap clip
(2) Quick Release Buckle w/ Strap (3) Length Adjustment (4) Emergency Breakaway |
Install sternum strap clips (1) onto the shoulder belt webbing so the center bar is on the inside of the belt.
Illustration 6 | g03453866 |
- Insert clip into buckle to fasten Sternum strap.
- Use length adjustment (3) to properly adjust the length of strap for a correct fit.
Note: Sternum strap should be adjusted so the belts fall smoothly and is not loose.
Illustration 7 | g03453876 |
- Pull Quick release (2) to release.