 |
Diesel engine exhaust contains products of combustion which may cause personal injury. Always start and operate the engine in a well ventilated area, and, if in an enclosed area, vent the exhaust to the outside. |
 |
| Required Tools | |||
|---|---|---|---|
| Tools | Part Number | Description | Qty |
| A | N/A | Laptop Computer with Plus+1TM Software | 1 |
| B (1) | 317-7485 | Communication Adapter | 1 |
| C (1) | 370-4617 | Cable As | 1 |
| D (1) | 327-8981 | Cable As | 1 |
| ( 1 ) | Tool (B), Tool (C), and Tool (D) are part of the 317-7484 Communication Adapter Gp . |
- Drive the machine to a smooth, horizontal surface.
- Move propel lever (1) to the NEUTRAL position.
 | |
| Illustration 1 | g03325453 |
- Move parking brake switch (2) to the ON position.
- Use throttle control switch (3) in order to operate the engine in ECO mode or in low idle.
Note: Two things indicate when the engine is in ECO mode. First, "ECO" will appear on the display. Second, the second LED next to throttle control switch (3) will be illuminated. Two things indicate when the engine is at low idle. First, "Low Idle" will appear on the display. Second, the first LED next to the throttle control switch will be illuminated.
- Move engine start switch (4) to the OFF position.
- Connect Tool (C) and Tool (D) to Tool (B). Connect Tool (D) to diagnostic connector (5). Connect Tool (C) to USB port on Tool (A) .
 | |
| Illustration 2 | g03325457 |
- Move engine start switch (4) to the START position. Release the switch when the engine starts.
- Use throttle control switch (3) in order to operate the engine in ECO mode or in low idle.
Note: Two things indicate when the engine is in ECO mode. First, "ECO" will appear on the display. Second, the second LED next to throttle control switch (3) will be illuminated. Two things indicate when the engine is at low idle. First, "Low Idle" will appear on the display. Second, the first LED next to the throttle control switch will be illuminated.
- Launch the Plus+1TM program on the computer.
Note: First time users need to perform the tasks in the Communication and Connections Wizard. This wizard allows the Windows® operating system to recognize the USB device. Follow the on screen instructions.
- Click on "Calibrations" icon (6) .
 | |
| Illustration 3 | g03325460 |
- Check "Active Codes" (9). Clear any open "Active Codes".
- Click on "Steering Solenoids" (7) .
- Click on "Start" icon (8) for the proper steering solenoid.
- Read and understand the safety requirements outlined on the warning page. Click "OK" icon (10) .
 | |
| Illustration 4 | g03325462 |
- Follow the steps on the Plus+1tm program in order to calibrate the steering valve threshold current.
- Move parking brake switch (2) to the ON position.
- Move throttle control switch (3) to the LOW IDLE position.
- Move engine start switch (4) to the OFF position.
- Remove tooling from diagnostic connector (5) .