Shipping Location of Keys for Machines Equipped with a Machine Security System (MSS) {7000, 7631}
- Articulated Truck:
- 725C (S/N: LFB1-UP; TFB1-UP)
- 730C (S/N: LFF1-UP; TFF1-UP)
- 730C EJECTOR (S/N: LFH1-UP; TFH1-UP)
- 735B (S/N: L4D1-UP; T4P1-UP)
- 740B (S/N: L4E1-UP; T4R1-UP)
- 740B EJECTOR (S/N: L4F1-UP; T4S1-UP)
Machines fitted with a Machine Security System (MSS) are shipped with two keys that are encoded to the MSS on the machine. The keys will have been enabled to the machine during assembly. The MSS is then disabled to allow any Caterpillar key to operate the machine up to delivery. Dealers will have to reconfigure the MSS to use the MMS keys shipped with the machine.
Show/hide table
 | |
| Illustration 1 | g02723043 |
(A) Key location under dash. | |
Show/hide table
 | |
| Illustration 2 | g02723045 |
Bag with keys. | |
The MSS keys are sealed in a plastic bag for shipping. This plastic bag is secured with a cable tie to the underside of the dash.
This information is effective for the following machines.
- 725C (S/N: LFB1-UP; TFB1-UP)
- 730C (S/N: LFF1-UP; TFF1-UP)
- 730C EJECTOR (S/N: LFH1-UP; TFH1-UP)
- 735B (S/N: L4D1-UP; T4P1-UP)
- 740B (S/N: L4E1-UP; T4R1-UP)
- 740B EJECTOR (S/N: L4F1-UP; T4S1-UP)
Caterpillar Information System:
Brake Hose for Front Axle Can Come Into Contact with Engine Coolant Lines{1380, 4257} Brake Hose for Front Axle Can Come Into Contact with Engine Coolant Lines{1380, 4257}
2011/10/19 New High Performance Seals are Available for Certain Backhoe Loaders {5456}
3516B and 3516C Engines for 789D Off-Highway Trucks Electrical Power Supply - Test
2011/12/14 New High Performance Seals are Available for Certain Backhoe Loaders {5457}
120M Series 2 Motor Grader Engine Supplement Radiator Guard and Support, Aftercooler, Hydraulic Oil Cooler, and Radiator - Remove and Install
Installation of the Cat® Detect Object Detection System 8 Radar Configuration for the 785 Off-Highway Truck {7347, 7348} Installation of the Cat® Detect Object Detection System 8 Radar Configuration for the 785 Off-Highway Truck {7347, 7348}
Engine Software Power Set Procedure for Tier 0 Software on 24M Motor Graders{1901, 1920, 7610, 7620} Engine Software Power Set Procedure for Tier 0 Software on 24M Motor Graders{1901, 1920, 7610, 7620}
C4.4 Engines for Caterpillar Built Machines Relief Valve (Fuel) - Remove and Install
R1600H Load Haul Dump Collet Pin Bolt Torque - Check
950M, 962M, 950M Z and 962M Z Wheel Loaders Water Pump - Install
793F AC Off-Highway Truck Power Train Speed Sensor (Front Wheel) - Inspect and Adjust
773G and 775G Quarry Trucks Chassis Electronic Control System MID 087 - CID 0171 - FMI 08
2012/10/23 An Updated Assembly Procedure Now Used for E-stick Upper Wear Pads on Certain Backhoe Loaders {6533}
CP34 and CS34 Vibratory Soil Compactors Diagnostic Capabilities
Machine Electronic Control System Electrical Component and Connector Locations
2011/09/19 Operator Techniques Can Improve Shift Quality on Certain Motor Graders {1265, 1269, 1918, 3065, 3167, 3168, 5705, 7000, 7300}
793F AC Off-Highway Truck Power Train Final Drive Lubrication Pressure - Test
793F AC Off-Highway Truck Hydraulic Fan and Steering System Wheel and Brake
120M Series 2 Motor Grader Engine Supplement Rear Chassis Support - Remove and Install
2011/09/27 Updated Torque Values for Relief Valve Plugs on Certain Backhoe Loaders {5051}
CB22B, CB24B, CB32B, CB34B, CB34B XW, CC24B and CC34B Vibratory Utility Compactors Machine Electronic Control System General Information
2011/09/19 Improved O-ring Seals for the Fuel Injection Lines Are Used in Certain 3500 Off-Highway Truck Engines {1252, 7555}
2011/09/28 A New Break-out Harness Is Used for the Fuel Control Module on C175 Off-Highway Truck Engines {1403, 1408}
SC-57 Felling Head General Hazard Information