Illustration 1 | g03408204 |
Pinning of the Extendable Stick (1)
If equipped, this message is located on the stick.
Illustration 2 | g01202535 |
The E-Stick must be pinned before using attachments, to prevent movement which could cause personal injury. |
Improper Location of the Backhoe Bucket (2)
This message is located by the linkage for the backhoe bucket.
Illustration 3 | g01202537 |
Improper bucket pin connection can cause machine damage. Make sure the bucket pins are connected properly. |
Data Privacy (3)
This message is located in the cab.
Illustration 4 | g01418953 |
Diesel Fuel Recommendations (4)
This message is located next to the fuel fill.
Illustration 5 | g02052934 |
Use Ultra Low Sulfur Diesel (ULSD) fuel.
The United States (U.S.) Environmental Protection Agency (EPA) defines Ultra-Low Sulfur Diesel (ULSD - S15) as a U.S. diesel fuel with a sulfur content not to exceed 15 parts per million (ppm(mg/kg)) or 0.0015 percent by weight. Engines certified to nonroad Tier 4 standards (Stage IV in Europe) and are equipped with exhaust aftertreatment systems are designed to run on ULSD only. Use of LSD or fuels higher than 15 ppm (mg/kg) sulfur in these engines will reduce engine efficiency and engine durability and will damage emissions control systems and/or shorten the service interval. Failures that result form the use of fuels are not Cat factory defects. Therefore the cost of repairs would not be covered by a Cat warranty.
In Europe, ultra low sulfur diesel fuel will have a maximum of 0.0010 percent (10 ppm(mg/kg)) sulfur and is typically referred to as "sulfur-free". This sulfur level is defined in European Standard "EN 590:2004".
Refer to Special Publication, SEBU6250, "Caterpillar Machine Fluids Recommendations" for more information about diesel fuels and sulfur.
Refer to Operation and Maintenance Manual, "Capacities (Refill)".
Required Engine Oil (5)
This message is located on top of the engine on the left side of the machine.
Illustration 6 | g02176761 |
Machine Hydraulic System (6)
The following message is located in the engine compartment.
Illustration 7 | g02096113 |
This machine hydraulic system is filled with Cat HYDO Advanced oil. The following message is located in the engine compartment.
Refer to Operation and Maintenance Manual, "Lubricant Viscosities" for more information about the hydraulic oil.
12 V (7)
The following message is located on the right side of the machine below the door.
Illustration 8 | g03407930 |