Electrohydraulic Control (Joystick) - Remove and Install
Note: Put identification marks on all harness assemblies for installation purposes.
- Position the arm assembly to the Forward position.
Show/hide table
Illustration 1 g02358688 - Remove screws (1). Repeat for the opposite side. Remove screws (2).
Show/hide table
Illustration 2 g02357176 - Remove cover assemblies (3).
Note: The inner cover can be positioned on the floor without disconnecting the arm rest latch cable.
Show/hide table
Illustration 3 g02357296 - Disconnect harness assembly (6). Remove screws (5) and electrohydraulic steering control (4).
- Install electrohydraulic steering control (4) in the reverse order of the removal.
- Tighten screws (1) and (5) to a torque of
6 ± 1 N·m (53 ± 9 lb in) . - Tighten screws (2) to a torque of
1.7 ± 0.4 N·m (15.0 ± 3.5 lb in) .
- Tighten screws (1) and (5) to a torque of
Caterpillar Information System:
3516B Engine for 994F and 994H Wheel Loaders Electrical Power Supply - Test
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System Wiring Harness (Short Circuit) - Test
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System Wiring Harness (Open Circuit) - Test
980M Tier 4 and 982M Tier 4 Wheel Loaders Machine Systems Steering Control Valve - Assemble
980M Tier 4 and 982M Tier 4 Wheel Loaders Machine Systems Steering Control Valve - Disassemble
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System Symptom Troubleshooting
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System Emerging Symptom Information
R1600G Load Haul Dump 3176C Engine Supplement Engine, Torque Converter and Updrive Gears - Install
C9.3 Tier 4 Final Engines Belt Tensioner - Alternator and Compressor
C13, C15, and C18 Tier 4 Final Engines Electric Starting Motor
Excessive Wear of the Crankshaft Rear Thrust Washer in Large Off-Highway Trucks{1202} Excessive Wear of the Crankshaft Rear Thrust Washer in Large Off-Highway Trucks{1202}
C9.3 Engines for Caterpillar Built Machines Rocker Arm and Shaft - Remove and Install
2011/05/25 Updated Cat EPD Alternator Failure Report Template Is Now Available for Cat Generator Sets {1404}
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System Cat Data Link
Cat® Detect Object Detection Camera - Clean
Cat® Detect Object Detection Configuration Screen
Cat® Detect Object Detection Diagnostic Summary Screen
Cat® Detect Object Detection Display - Clean
Cat® Detect Object Detection Display Navigation
Cat® Detect Object Detection General Information
Cat® Detect Object Detection Main Screen
Cat® Detect Object Detection Object Detection Sensor - Clean/Inspect
Cat® Detect Object Detection Regulatory Compliance
Cat® Detect Object Detection Safety