Electric Starting Motor
Show/hide table
 | |
| 图 1 | g02567276 |
Show/hide table
| 348-7651 电起动马达总成 技术规格 | |||
| 项目 | 数量 | 零件 | 技术规格说明 |
| 1 | 1 | 4B-2049 螺母 | 拧紧至扭矩为 3.4 ± 1.2 N·m (30.1 ± 10.6 lb in)。 |
| 2 | 1 | 4B-2049 螺母 | 开关端子必须用热收缩管绝缘。 不要使用模压端子。 拧紧至扭矩为 3.4 ± 1.2 N·m (30.1 ± 10.6 lb in)。 |
| 3 | 3 | 6V-8188 螺母 | 拧紧至扭矩为 30.5 ± 3.5 N·m (269.9 ± 31.0 lb in)。 |
| 4 | 1 | 6V-8188 螺母 | 蓄电池端子螺母最多可使用三条电缆或导线端子。 两个端子最高不低于 0 AWG。 拧紧至扭矩为 30.5 ± 3.5 N·m (269.9 ± 31.0 lb in)。 |
| - | - | - | 系统电压为 24 V。 |
| - | - | - | 25 °C (77 °F) 时的无负载性能： 转速为 6950 ± 1650 rpm 电流为 115 ± 25 安培 电压为 23 V |
| 将电起动马达安装在可将电磁阀组件放置在离水平线上方不小于 15 度位置的地方上。 | |||
| 当从小齿轮端观看电起动马达时，马达顺时针旋转。 | |||
Caterpillar Information System:
Excessive Wear of the Crankshaft Rear Thrust Washer in Large Off-Highway Trucks{1202} Excessive Wear of the Crankshaft Rear Thrust Washer in Large Off-Highway Trucks{1202}
C9.3 Engines for Caterpillar Built Machines Rocker Arm and Shaft - Remove and Install
C9.3 Engines for Caterpillar Built Machines Compression Brake - Remove and Install
142-1664 Adjustable Lifting Bracket Group{0599, 0629, 0700, 0729, 0757, 1122} 142-1664 Adjustable Lifting Bracket Group{0599, 0629, 0700, 0729, 0757, 1122}
C9.3 Engines for Caterpillar Built Machines Valve Mechanism Cover - Remove and Install
C9.3 Engines for Caterpillar Built Machines Cylinder Block Cover - Remove and Install
2011/05/26 An Improved Relief Valve Group is Now Used in the Torque Converter Filter and Lines Group on the 777F Off-Highway Trucks {3103}
2011/07/11 A New Backup Ring Improves the Rear Suspension Group on Certain Off-Highway Trucks {7201, 7213}
C3.4B Industrial Engine Monitoring System
C3.4B Industrial Engine Gauges and Indicators
SC-57 Felling Head Felling Head Relief Valve (Line) - Test and Adjust
C13, C15, and C18 Tier 4 Final Engines Connecting Rod
C9.3 Tier 4 Final Engines Belt Tensioner - Alternator and Compressor
R1600G Load Haul Dump 3176C Engine Supplement Engine, Torque Converter and Updrive Gears - Install
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System Emerging Symptom Information
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System Symptom Troubleshooting
980M Tier 4 and 982M Tier 4 Wheel Loaders Machine Systems Steering Control Valve - Disassemble
980M Tier 4 and 982M Tier 4 Wheel Loaders Machine Systems Steering Control Valve - Assemble
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System Wiring Harness (Open Circuit) - Test
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System Wiring Harness (Short Circuit) - Test
3516B Engine for 994F and 994H Wheel Loaders Electrical Power Supply - Test
980M Tier 4 and 982M Tier 4 Wheel Loaders Machine Systems Electrohydraulic Control (Joystick) - Remove and Install
2011/05/25 Updated Cat EPD Alternator Failure Report Template Is Now Available for Cat Generator Sets {1404}
914G Compact Wheel Loader and IT14G Integrated Toolcarrier Transmission Electronic Control System Cat Data Link