Inlet and Exhaust Valve Guides - Remove and Install
Show/hide table
| 所需工具 | |||
| 工具 | 零件号 | 零件描述 | 数量 |
| A | 4C-6366 | 气门导管冲头 | 1 |
| B | 476-2132 | 导向圈 | 1 |
| C | - | 直尺 | 1 |
开始:
- 拆下进气门和排气门。
Show/hide table
| 注意 |
|---|
|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 使用工具 (A) 从缸盖组件上拆下气门导管 (1)。
Show/hide table
| |
| 图 1 | g02167333 |
- 按与拆卸相反的顺序安装气门导管 (1)。
- 将清洁的发动机机油涂抹到气门导管的外径和内径上。 将气门导管放置到缸盖中。 轻敲气门导管的顶部。 此动作可将进气门导管和排气门导管敲入缸盖组件中。
- 使用工具 (A) 和工具 (B) 安装气门导管。 将直尺横放在气门室盖底座密封表面上。 从气门导管的顶部到直尺的底部进行测量。 这个测量值称为距离 (C)。 距离 (C) 应为
44 ± 0.5 mm (1.7 ± 0.02 inch) 。
Show/hide table
图 2 g02166659 此照片显示了缸盖和工具的剖面图。 Show/hide table
图 3 g02166757
Caterpillar Information System:
C9.3 Engines for Caterpillar Built Machines Inlet and Exhaust Valves - Remove and Install
2011/07/20 An Updated Procedure for the Inspection, Repair, and Component Replacement on the Frames of Certain Off-Highway Trucks is Available {7000, 7051}
AP1000F Asphalt Paver Machine Systems Final Drive Planetary - Install
AP1000F Asphalt Paver Machine Systems Final Drive Planetary - Remove
AP1000E and BG1000E Asphalt Pavers Machine Systems Piston Motor (Propel) - Install
AP1000E and BG1000E Asphalt Pavers Machine Systems Piston Motor (Propel) - Remove
3516B Engine for 994F and 994H Wheel Loaders Configuration Parameters
777G Off-Highway Truck Lubrication Pump Oil - Change
Comfort Series Seat For Caterpillar Machines Optimized Seat with Lumbar, Side Controls, and Slide Swivel
777G Off-Highway Truck Lubrication Pump Oil Level - Check
2011/05/26 New Cylinder Pack Assemblies Are Available in Sets for Certain Machines Equipped with C18 Engines {1201, 1216, 1225, 1239}
C13, C15, and C18 Tier 4 Final Engines Exhaust Gas Valve (NRS)
C9.3 Engines for Caterpillar Built Machines Inlet and Exhaust Valve Seat Inserts - Remove and Install
Front Axle Steering Cylinder Hose Guard for Certain M Series Motor Graders{7164} Front Axle Steering Cylinder Hose Guard for Certain M Series Motor Graders{7164}
E SeriesBackhoe Loader Stabilizer Cylinder Drift{5468} E SeriesBackhoe Loader Stabilizer Cylinder Drift{5468}
541 Series 2 and 552 Series 2 Track Feller Bunchers Condenser (Refrigerant) - Clean
521B and 522B Track Feller Bunchers Monitoring System - System Setup and Change
793F Off-Highway Truck Damper (Crankshaft) - Inspect
C9.3 Tier 4 Final Engines Electronic Unit Injector Wiring
C175-16 and C175-20 Generator Set Engines Fuel Injector
C4.4 Engines For Caterpillar Built Machines CID 0001 FMI 05
C4.4 Engines For Caterpillar Built Machines CID 0001 FMI 06
C4.4 Engines For Caterpillar Built Machines CID 0002 FMI 05
C4.4 Engines For Caterpillar Built Machines CID 0002 FMI 06