Flywheel - Install
安装步骤
Show/hide table
所需工具     | |||
---|---|---|---|
工具     | 零件号     | 零件说明     | 数量     |
A     | 138-7575     | 提升支架     | 2     |
B     | -     | 导向螺柱 5/8 - 18 x 8 in     |
2     |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 加热齿圈 (3) 。 将齿圈 (3) 安装在飞轮 (2) 上。
Show/hide table
图 1 | g01091705 |
注: 安装齿圈 (3) 的时候应让轮齿斜面一侧朝上。 当飞轮安装完毕之后,轮齿斜面一侧应朝向起动马达。
- 将工具 (B) 安装在曲轴中。
Show/hide table
图 2 | g01091639 |
- 将工具 (A) 和适当的起吊设备安装在飞轮 (2) 上。 飞轮 (2) 的重量约为 85 kg (185 lb)。 将飞轮安置在曲轴上。
- 在螺栓 (1) 的螺纹上涂抹清洁的发动机机油。
- 安装螺栓 (1) 。 拆下工具 (B) 。 将螺栓 (1) 安装在工具 (B) 的位置上。
- 拧紧螺栓 (1) 至扭矩为 100 ± 5 N·m (75 ± 4 lb ft)。
- 再将螺栓 (1) 转动 90 ± 5 度。
注: 在维修点处更换螺栓 (1) 。
- 将工具 (A) 从飞轮上拆下。
- 检查飞轮跳动。 请参阅测试与调整, "飞轮 - 检查"。
End By: 安装发电机。 请参阅 拆解和组装, "发电机 - 安装"。
Caterpillar Information System:
2008/11/01 Do Not Use the 6V-4022 Fuel Injector Tester to Measure Unit Injector Fuel Flow Rate {0782, 1251, 1254, 1290, 1713}
12K, 140K and 160K Motor Graders Engine Air Filter Service Indicator - Inspect/Replace
2008/11/17 Do Not Use the 6V-4022 Fuel Injector Tester to Measure Unit Injector Fuel Flow Rate {1251, 1254, 1290, 1713}
2009/01/26 The List of Approved Telehandler Work Tools Has Been Updated {6459, 6501, 6542, 6700, 7405}
120K and 120K Series 2 Motor Graders Hydraulic and Steering System Pump Control Valve (Implement, Steering) - Test and Adjust
120K and 120K Series 2 Motor Graders Hydraulic and Steering System Hydraulic and Steering System
2008/11/17 Calibration Fluid for Fuel Nozzle Test Equipment Is Available {0782, 1251, 1254, 1290, 1713}
793F and 793F CMD Off-Highway Truck Power Train Temperature Sensor (Engine Coolant)
CB54, CB54 XW and CB64 Vibratory Compactor Propel System Direction and Speed Control
C9.3 Engines for Caterpillar Built Machines Fuel System Pressure - Test
3306C Engines for Caterpillar Built Machines Turbocharger
120K and 120K Series 2 Motor Graders Power Train Clutch Control (Modulation)
C7 Engines for Caterpillar Built Machines Diagnostic Trouble Codes
C7 Engines for Caterpillar Built Machines Component Location
C9 Engine and D7E Track-Type Tractors Fuel Rail Pressure Is Low
Roll Over Protective Structure and Falling Object Protective Structure Identification Film Retention{7000, 7405, 7557} Roll Over Protective Structure and Falling Object Protective Structure Identification Film Retention{7000, 7405, 7557}
2008/11/17 The Pop (Injector) Tester Is not Available for Fuel Injectors {0782, 1251, 1254, 1290, 1713}
2008/11/17 The Pop (Injector) Tester Is not Available for Fuel Injectors {0782, 1251, 1254, 1290, 1713}
AccuGrade Remote Switch Installation{7220, 7332, 7451} AccuGrade Remote Switch Installation{7220, 7332, 7451}
EquipmentManager User Guide Product Usage
2008/11/24 A New Procedure is Now Used to Install a New Cover for the Water Pump on Paving Compactors {5614}
Procedure to Install a New Cover for the Water Pump on Paving Compactor{5614} Procedure to Install a New Cover for the Water Pump on Paving Compactor{5614}
793F and 797F Off-Highway Trucks Braking System MID 116 - CID 0041 - FMI 03
2008/11/17 The 6V-4022 Fuel Injector Tester should not be Used to Check Unit Injectors for Leaks {0782, 1251, 1254, 1290, 1713}