Engine Oil Scavenge Pump
Show/hide table
| |
| 图 1 | g03836650 |
Show/hide table
| 技术规格 - 144-8267 发动机扫油泵 | |||
|---|---|---|---|
| 项目 | 数量 | 零件 | 技术规格说明 |
| 从驱动端观看扫油泵时，驱动装置按逆时针方向旋转。 | |||
| 1 | 4 | 3H-2750 螺栓 | 拧紧至扭矩为 |
| 2 | 2 | 237-7623 O 形密封圈 | 使用润滑剂稍微润滑即将密封的孔。 |
Show/hide table
| |
| 图 2 | g03836651 |
|
剖面 A-A | |
Show/hide table
| 项目 | 数量 | 零件 | 技术规格说明 |
|---|---|---|---|
| 3 | 1 | 0S-0484 螺栓 | 采用下述步骤拧紧螺栓： 将驱动齿轮安装到驱动轴组件前，用异丙醇清洁轴和齿轮孔。 1. 敲打驱动齿轮以座合驱动齿轮的锥形部分。 2. 拧紧螺栓至扭矩 3. 重复步骤 1 和步骤 2，直到扭矩不变。 |
| A | 1 | 144-8272 齿轮 | 新齿轮的长度为 扫油泵体中新齿轮孔的深度为 |
| B | 1 | 161-2511 驱动轴 | 新驱动轴的直径为 套筒轴承中新驱动轴的孔径为 |
| C | 1 | 144-8270 惰轮轴 | 新惰轮轴的直径为 套筒轴承中新惰轮轴的孔径为 |
| D | 2 | 1W-6005 衬套 | 衬套在 144-8265 扫油泵体上的安装深度为 |
Show/hide table
| |
| 图 3 | g03836653 |
Show/hide table
| |
| 图 4 | g03836655 |
Show/hide table
| 注意 |
|---|
|
操作之前，必须使用干净的发动机机油润滑泵体，并且泵必须能灵活运转，否则就会导致部件的损坏。 |
Show/hide table
| 项目 | 数量 | 零件 | 技术规格说明 |
|---|---|---|---|
| E | - | - | 从中线穿过轴承孔的轴承接头位置为 45 ± 15 度。 |
| F | 2 | 4M-3248 空心定位销 | 空心定位销自扫油泵盖的延伸长度为 |
| G | 2 | 1W-6005 衬套 | 7N-8814 扫油泵盖上的衬套安装深度为 |
Caterpillar Information System:
PS-360B Paving Compactor Air Tank Moisture and Sediment - Drain
C4.4 and C6.6 Engines for Caterpillar Built Machines E232 High Fuel/Water Separator Water Level
C4.4 and C6.6 Engines for Caterpillar Built Machines E194 High Exhaust Temperature
C4.4 and C6.6 Engines for Caterpillar Built Machines E172 High Air Filter Restriction
793F AC Off-Highway Truck Power Train Drive Shaft (Main)
CD54 Paving Compactor Fuel System - Fill
2008/03/31 Reuse Information on the Components in the Drive Train {3278, 4050}
RM-300 Reclaimer Mixer Machine Systems Water Spray System
2008/03/10 The Spring for The Injector is More Durable {1251, 1290}
D-Series and D2-Series Compact Track Loaders (CTL), Multi-Terrain Loaders (MTL), and Skid Steer Loaders (SSL) Angle Blade Operation
RM-300 Reclaimer Mixer Machine Systems Emulsion Spray System
CB22, CB24, CB32 and CC24 Vibratory Compactors Machine Systems Vibratory Valve - Install
AS2252C Asphalt Screed Screed Components
2008/03/10 Improved Clamping Is Used for the Lower Water Lines {1380}
CB-434D, CB-534D and CB-564D Asphalt Compactors Diagnostic Trouble Code List
Hose Installation on 572RSeries II (S/N: DSC) and 572R (S/N: AAC) Pipelayers{5057} Hose Installation on 572RSeries II (S/N: DSC) and 572R (S/N: AAC) Pipelayers{5057}
795F AC and 795F AC XQ Off-Highway Trucks Retarding
AS2252C Asphalt Screed Screed Control System
PL61 Pipelayer and D6K Track-Type Tractor MID 039 - CID 2143 - FMI 09
MINEGEM Machine Control ; Guidance Products Display Description
C15 Petroleum Generator Set Engines Speed/Timing Sensor
2008/03/17 An Improved Fuel Level Sender is Now Available {7481}
AS2252C Asphalt Screed Electric Heat System
C4.4 and C6.6 Engines for Caterpillar Built Machines E441 Idle Elevated to Increase Battery Voltage