Hydraulic Tank (Hoist, Brake) - Install
安装步骤
Show/hide table
所需工具     | |||
工具     | 零件号     | 零件说明     | 数量     |
A     | 138-7573     | 连杆支架     | 2     |
- 将适当的起吊设备和工具 (A) 固定到液压油箱 (17) 上。 液压油箱 (17) 的重量约为 147 kg (325 lb)。
Show/hide table
图 1 | g01404527 |
- 安置液压油箱 (17) 并将螺栓 (18) 安装到机器两侧。
- 连接软管组件 (20) 和管组件 (19) 。
- 安装螺栓 (13) 。 连接管组件 (16) 和 (12) 。 连接软管 (15) 并拧紧卡箍 (14) 。
Show/hide table
图 2 | g01404526 |
- 连接软管组件 (11) 。 安置阀 (10) ,然后安装螺栓 (9) 。
Show/hide table
图 3 | g01404525 |
- 将适当的起吊设备连接到泵组件 (6) 上。 泵组件 (6) 的重量约为 27 kg (60 lb)。
Show/hide table
图 4 | g01404524 |
- 安置盖组件 (6) 并安装螺栓 (8) 。 安装新的电缆系带 (7) 。
- 连接线束组件 (4) ,然后安装新电缆带 (5) 。
Show/hide table
图 5 | g01404522 |
- 将适当的起吊设备和工具 (A) 固定到盖组件 (2) 上。 盖组件 (2) 的重量约为 27 kg (60 lb)。
Show/hide table
图 6 | g01404519 |
- 安置盖组件 (2) 并安装螺栓 (3) 。
- 连接润滑脂软管组件 (1) 。
Show/hide table
图 7 | g01404518 |
- 向液压油箱注油。 请参阅操作和保养手册, "举倾机构和制动器油箱油 - 更换"。
- 对泵和制动器排气。 请参阅测试和调整, "齿轮泵(制动器、举倾机构、液压风扇)- 排气"。
End By: 拆下销后降下车斗。 请参阅 拆解和组装, "销(车斗固定)- 拆卸和安装"。
Caterpillar Information System:
770 and 772 Off-Highway Truck/Tractors Hydraulic Tank (Hoist, Brake) - Remove
24M Motor Grader Power Train Drive Chain
160M Motor Grader Machine Systems Steering Control Valve - Remove
Universal Joints and Drive Shafts {3108, 3251, 3253} Universal Joints and Drive Shafts {3108, 3251, 3253}
Reusability of Tapered Bearings {7000, 7551} Reusability of Tapered Bearings {7000, 7551}
770 and 772 Off-Highway Truck/Tractors Slack Adjuster (Rear) - Install
770 and 772 Off-Highway Truck/Tractors Slack Adjuster (Rear) - Remove
3176C Engine for Caterpillar Built Machines Alternator Problem - Charging Problem and/or Noisy Operation
14L Motor Grader Machine Systems Solenoid Valve and Manifold (Hydraulic Fan) - Remove and Install
3412E Engine for Caterpillar Built Machines Acceleration Is Poor or Throttle Response Is Poor
Track Data Charts {0372, 0374, 4170} Track Data Charts {0372, 0374, 4170}
770 and 772 Off-Highway Truck/Tractors Piston Pump (Steering) - Install
2007/08/20 New Routing of Hoses on the Extendable Stick Bucket Improves Service Life {5057, 6533}
160M Motor Grader Machine Systems Steering Control Valve - Install
C7 Engines for Caterpillar Built Machines Engine Oil Filter Base
854K Wheel Dozer Camera - Clean - If Equipped
160M Motor Grader Machine Systems Control Manifold (Steering Backup) - Remove
160M Motor Grader Machine Systems Control Manifold (Steering Backup) - Install
2007/08/20 Improved Sealing for Torque Limiter on Hydraulic Pump {5070}
160M Motor Grader Machine Systems Secondary Steering Pump and Motor - Remove
160M Motor Grader Machine Systems Secondary Steering Pump and Motor - Install
770 and 772 Off-Highway Truck/Tractors Cab - Remove
770 and 772 Off-Highway Truck/Tractors Cab - Install
CP54 and CS54 Vibratory Soil Compactors Machine Systems Front Bumper