Exhaust Manifold - Remove and Install
拆卸步骤
开始:
- 拆下涡轮增压器。 请参阅拆解和组装, "涡轮增压器 - 拆卸"。
- 拆下水温调节器壳体。 请参阅拆解和组装, "水温调节器 - 拆卸和安装"。
- 拆下锁紧螺母 (2) 和隔套 (1) 。
Show/hide table
图 1 | g01095489 |
- 拆下排气歧管 (3) 。
- 拆下排气歧管 (4) 。
- 如有必要,将拔梢锁紧双头螺柱从缸盖上拆下。
安装步骤
Show/hide table
所需工具     | |||
工具     | 零件号     | 零件说明     | 数量     |
A     | 5P-3931     | 防粘结剂     | -     |
Show/hide table
注意 |
---|
保持所有零件清洁无杂质。 杂质会造成快速磨损和缩短部件寿命。 |
- 将拔梢锁紧双头螺柱安装在缸盖上并拧紧至扭矩为 35 ± 5 N·m (26 ± 4 lb ft)。
- 将排气歧管密封垫 (4) 安装在拔梢锁紧双头螺柱上。
Show/hide table
图 2 | g01095489 |
- 将排气歧管 (3) 安置在拔梢锁紧双头螺柱上, 安装隔套 (1) 。
- 将工具 (A) 涂抹在拔梢锁紧双头螺柱的螺纹上。 安装锁紧螺母 (2) 并拧紧至扭矩为 38 ± 5 N·m (28 ± 4 lb ft)。
注: 使用后请丢弃锁紧螺母。 安装时请使用新的锁紧螺母。
End By:
- 安装水温调节器壳体 3。 请参阅 拆解和组装, "水温调节器 - 拆卸和安装"。
- 安装涡轮增压器。 请参阅 拆解和组装, "涡轮增压器 - 安装"。
Caterpillar Information System:
120M and 12M Motor Graders Braking and Hydraulic Fan System Control Manifold (Brake, Hydraulic Fan)
770 and 772 Off-Highway Trucks Engine Supplement Radiator Core - Install
770 and 772 Off-Highway Trucks Engine Supplement Radiator Core - Remove
120M and 12M Motor Graders Braking and Hydraulic Fan System Brake Accumulator Charging Valve - Check
140M Motor Grader Engine Supplement Flywheel Housing - Remove and Install
12M, 140M and 160M Motor Graders Braking and Hydraulic Fan System Piston Pump (Brake, Hydraulic Fan) Margin Pressure - Test and Adjust
12M, 140M and 160M Motor Graders Braking and Hydraulic Fan System Piston Pump (Brake, Hydraulic Fan) High Pressure Stall - Test and Adjust
938H Wheel Loader and IT38H Integrated Toolcarrier Braking and Hydraulic Fan System Service Brakes
CB14 Paving Compactor Machine Systems Direction and Speed Control - Install
CB14 Paving Compactor Machine Systems Direction and Speed Control - Remove
587R Pipelayer Machine Systems Gear Pump (Counterweight) - Assemble
587R Pipelayer Machine Systems Gear Pump (Counterweight) - Disassemble
CB14 Paving Compactor Machine Systems Lifting Gp - Remove and Install
AS3251C Asphalt Screed Operator Platform
2007/07/09 Use of Dry Lubricant is Recommended {0645, 7301}
120M and 12M Motor Graders Braking and Hydraulic Fan System Piston Pump (Brake, Hydraulic Fan)
2007/06/18 An Updated Procedure for Starting the Engine of a Skid Steer Loader or Multi Terrain Loader is Available {1000, 7000}
14L Motor Grader Drive Shaft - Remove and Install
CB14 Paving Compactor Machine Systems Rollover Protective Structure (ROPS) - Remove and Install
160M Motor Grader Power Train Transmission - Remove
AS3301C Asphalt Screed End Gate
CS54 and CP54 Vibratory Soil Compactors Cooling System Coolant (ELC) - Change
CB14 Paving Compactor Machine Systems Diaphragm Pump (Water Spray) - Remove and Install
WAVS Installation Guide for Generic Applications{7347, 7348} WAVS Installation Guide for Generic Applications{7347, 7348}