Configuration
Required Tools     | ||
Part Number     | Description     | Quantity     |
JEBD3003     | Caterpillar Electronic Technician (ET)     | 1     |
171-4401     | Communications Adapter II     | 1     |
207-6845     | Adapter Cable As     | 1     |
160-0141     | Adapter Cable As     | 1     |
The Caterpillar Electronic Technician (ET) service tool is used to access the configuration screen. A message on the Cat ET screen will give instructions that guide the user through the procedure. Refer to the Manual that is provided with the Cat ET software for more information about Cat ET.
Illustration 1 | g01369908 |
Panel that is located on the left side of the seat in the operator's compartment (1) Service Connector for the Data Link |
An ECM must be configured when the ECM has been replaced. The configuration screen is only for machines with an ECM. The ECM needs to be configured before a calibration can be started.
A check of the configuration screen could resolve a problem with the machine. A problem with a component could be identified as one of the following items:
- The component is not installed.
- The component is installed but a change to the installation is needed in order to correct a problem.
Follow these instructions to get to the configuration screen:
- Connect the communications adapter and the computer to the diagnostic service tool connector.
- Start the Cat ET.
- Select "File". Go to "Select ECM". Choose the "AWD ECM".
- Go to the "Service" Menu. Select "Configuration". Click "OK".