AS3301C Asphalt Screed Caterpillar


Vibratory Group - Assemble

Usage:

AS3301C DWM

Assembly Procedure

Main




    Illustration 1g01305254

  1. Use a rubber hammer in order to install bearing (3) onto vibratory shaft (1) .

  1. Install set screws (2) in bearings (3) .

Extender




    Illustration 2g01305256

  1. Install bearing (3) on shaft (1) and tighten setscrews (2) .

  1. Install bearing (4) on shaft (1) and tighten setscrews (5) .

  1. Install the shaft key on shaft (1). Install coupling (7) on shaft (1) and tighten setscrews (6) .

End By:

  1. Install the vibratory group (extender). Refer to Disassembly and Assembly, "Vibratory Group - Install".
  2. Install the vibratory group (main frame). Refer to Disassembly and Assembly, "Vibratory Group - Install".

Caterpillar Information System:

AS3301C Asphalt Screed Vibratory Group - Disassemble
AS3251C Asphalt Paver Vibratory Group - Remove
AS3301C Asphalt Screed Gear Motor (Vibratory) - Install
AS3301C Asphalt Screed Gear Motor (Vibratory) - Remove
Procedure to Install an Improved Ventilation System on the Asphalt Pavers{6654} Procedure to Install an Improved Ventilation System on the Asphalt Pavers{6654}
AS3301C Asphalt Screed Height Adjuster Jack (End Gate) - Remove and Install
AS3301C Asphalt Screed Shoe (End Gate) - Remove and Install
C175-16 and C175-20 Engines for Off-Highway Trucks Water Pump
793F Series AC Off-Highway Truck Machine Systems Solenoid and Manifold Valve (Steering) - Assemble
793F Series AC Off-Highway Truck Machine Systems Solenoid and Manifold Valve (Steering) - Disassemble
TK711, TK721, TK722, TK732, TK741, TK751 and TK752 Track Feller Bunchers IQAN MDM Monitor Fault ; Event Codes Using the Operator Monitor to Determine Diagnostic Codes
TK711, TK721, TK722, TK732, TK741, TK751 and TK752 Track Feller Bunchers IQAN MDM Monitor Fault ; Event Codes CAN-Low at VBAT IQAN XT2 A0
AS3251C Asphalt Paver Vibratory Group - Install
120M, 12M, 140M, 14M, 160M and 16M Motor Graders Secondary Steering System Control Manifold (Steering Backup) - Test
C175-16 and C175-20 Engines for Off-Highway Trucks Cylinder Block - Type 1
814F Series 2 Wheel Dozer, 815F Series 2 Soil Compactor and 816F Series 2 Landfill Compactor Braking System Position Sensor (Left Brake Pedal) (Decelerator)
777E, 777F and 777G Off-Highway Truck Magnetic Switch (Prelubrication Relay) - Remove and Install
C9 Engine for the 816F Series 2 Landfill Compactor, the 815F Series 2 Soil Compactor, and the 814F Series 2 Wheel Dozer Inlet Air Is Restricted
777E, 777F and 777G Off-Highway Truck Muffler - Remove and Install
2007/04/23 A New Hystat Pump Improves Reliability {3203, 5070}
450E Backhoe Loader Axles, Differential and Brakes Wheel and Tire (Rear) Wheel and Tire (Rear)
814F Series 2 Wheel Dozer, 815F Series 2 Soil Compactor and 816F Series 2 Landfill Compactor Power Train Transmission Pressures - Test and Adjust
CP54 and CS54 Vibratory Soil Compactors Engine Supplement Air Cleaner - Remove and Install
120M, 12M, 140M, 14M, 160M and 16M Motor Graders Power Train Electronic Control System MID 027 - CID 1960 - FMI 09
Back to top
The names Caterpillar, John Deere, JD, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
CH-Part.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only.