Gear Motor (Vibratory) - Install
Installation Procedure
Extender Frame
- Install gear motor (2) to mount assembly (4) . Install bolts (9) , the washers, and the nuts.
Show/hide table
Illustration 1 | g01383457 |
- Install coupling assembly (7) . Do not tighten set screw (8) at this time.
- Install mount assembly (4) and gear motor (2) .
Show/hide table
Illustration 2 | g01383437 |
- Install bolts (6) .
- Connect hose assembly (5) to gear motor (2) .
- Coupling assembly (7) and the vibratory shaft should have no more than .5 Degrees of angular misalignment and 0.38 mm (0.02 inch) of parallel misalignment. Tighten set screw (8) .
Show/hide table
Illustration 3 | g01386247 |
- Connect hose assemblies (3) and (1) to gear motor (2) .
Show/hide table
Illustration 4 | g01383444 |
Main Frame
- Install gear motor (4) to mount assembly (8) . Install bolts (11) .
Show/hide table
Illustration 5 | g01383421 |
- Install coupling (9) . Do not tighten set screw (10) at this time.
- Install mount (8) and gear motor (4) .
Show/hide table
Illustration 6 | g01383400 |
- Install bolts (7) .
- Connect hose assemblies (6) , (5) , and (3) to gear motor (4) .
- Coupling assembly (9) and the vibratory shaft should have no more than .5 Degrees of angular misalignment and 0.38 mm (0.02 inch) of parallel misalignment. Tighten set screw (10) .
Show/hide table
Illustration 7 | g01386294 |
- Install cover (2) and bolts (1) .
Show/hide table
Illustration 8 | g01383398 |
End By: Install the deflector plates (extender). Refer to Disassembly and Assembly, "Deflector Plates (Strike-Off) - Remove and Install".
Caterpillar Information System:
AS3301C Asphalt Screed Gear Motor (Vibratory) - Remove
Procedure to Install an Improved Ventilation System on the Asphalt Pavers{6654} Procedure to Install an Improved Ventilation System on the Asphalt Pavers{6654}
AS3301C Asphalt Screed Height Adjuster Jack (End Gate) - Remove and Install
AS3301C Asphalt Screed Shoe (End Gate) - Remove and Install
C175-16 and C175-20 Engines for Off-Highway Trucks Water Pump
793F Series AC Off-Highway Truck Machine Systems Solenoid and Manifold Valve (Steering) - Assemble
793F Series AC Off-Highway Truck Machine Systems Solenoid and Manifold Valve (Steering) - Disassemble
TK711, TK721, TK722, TK732, TK741, TK751 and TK752 Track Feller Bunchers IQAN MDM Monitor Fault ; Event Codes Using the Operator Monitor to Determine Diagnostic Codes
TK711, TK721, TK722, TK732, TK741, TK751 and TK752 Track Feller Bunchers IQAN MDM Monitor Fault ; Event Codes CAN-Low at VBAT IQAN XT2 A0
793D Off-Highway Truck/Tractor Solenoid and Manifold Valve (Steering) - Install
TK711, TK721, TK722, TK732, TK741, TK751 and TK752 Track Feller Bunchers IQAN MDM Monitor Fault ; Event Codes CAN-Low at VBAT IQAN XP2 A1
793D Off-Highway Truck/Tractor Solenoid and Manifold Valve (Steering) - Remove
AS3251C Asphalt Paver Vibratory Group - Remove
AS3301C Asphalt Screed Vibratory Group - Disassemble
AS3301C Asphalt Screed Vibratory Group - Assemble
AS3251C Asphalt Paver Vibratory Group - Install
120M, 12M, 140M, 14M, 160M and 16M Motor Graders Secondary Steering System Control Manifold (Steering Backup) - Test
C175-16 and C175-20 Engines for Off-Highway Trucks Cylinder Block - Type 1
814F Series 2 Wheel Dozer, 815F Series 2 Soil Compactor and 816F Series 2 Landfill Compactor Braking System Position Sensor (Left Brake Pedal) (Decelerator)
777E, 777F and 777G Off-Highway Truck Magnetic Switch (Prelubrication Relay) - Remove and Install
C9 Engine for the 816F Series 2 Landfill Compactor, the 815F Series 2 Soil Compactor, and the 814F Series 2 Wheel Dozer Inlet Air Is Restricted
777E, 777F and 777G Off-Highway Truck Muffler - Remove and Install
2007/04/23 A New Hystat Pump Improves Reliability {3203, 5070}
450E Backhoe Loader Axles, Differential and Brakes Wheel and Tire (Rear) Wheel and Tire (Rear)