Usage:
Start By:
a. remove timing gear cover
 |
Do not disconnect the air line from the air compressor governor until the air pressure is zero. |
 |
1. Loosen the bleed valves, and release the air pressure in the air tank.
2. Disconnect the lines from air compressor (1), and remove the air compressor.
3. Remove sleeve (2) from air compressor drive gear (3).
4. Remove the nut and washer that holds the air compressor drive gear to the air compressor. Use tooling (A) to remove air compressor drive gear (3) from the air compressor.
5. Remove nuts (4) and plate (5). Remove gear assembly (6) from the shaft.
6. If damaged, remove bearing (7) from gear assembly (6) with tooling (B) and a press.
7. Remove three nuts (8) and the washers from the adapter assembly studs.
8. Remove adapter assembly (9) from the timing gear plate.
9. Remove shaft (10), O-ring seal (11) and sleeve (12) from the adapter assembly.
Install Air Compressor And Accessory Drive
1. Install sleeve (12) into the adapter assembly.
2. Install shaft (10) and O-ring seal (11) on the adapter assembly.
3. Put adapter assembly (9) in position on the timing gear plate. fasten it with the three nuts and washers.
4. Install the bearing in gear assembly (6) with tooling (A) and a press. Install the bearing until it is 1.5 ± 0.5 mm (.06 ± .02 in.) below the surface of the gear as shown.
5. Put gear assembly (6) in position on the shaft.
6. Put plate (5) in position, and install three nuts (4) to hold it.
7. Put air compressor drive gear (3) in position on the air compressor shaft, and install the washer and nut (13). Tighten the nut to a torque of 200 ± 25 N·m (150 ± 18 lb.ft.). Tap the gear with a hammer and tighten nut again to a torque of 200 ± 25 N·m (150 ± 18 lb.ft
8. Install sleeve (2) on gear (3).
9. Put a gasket in position on air compressor (1) and install the air compressor on the timing cover plate.
End By:
a. install timing gear cover